DBSR453EB2CC General Electric Dryer - Instructions

Verified start switch was defective by jumping around switch to confirm the unit operated. replaced the switch.

Took the top of the dryer off by removing two philips screws in front. Removed two screws holding the front of the dryer on. Pulled the front out enough to reveal the worn drum slides. Replaced them. Reassembled.

All is necessary is remove 3 philip screws, remove the switch knob, lift a tab on the switch, rotate the switch counterclockwise and it was out. Pull wires off switch and immediately put them on the corresponding terminals of the new switch before reversing the above steps. Simple!!!

Took the front & top off the dryer. Saw that the slides were missing or broken. Got the parts and put it back together. Works great.

Started out by unplugging appliance then pulled off knob, removed 4 screws that held cover in place, removed wires from switch, rotated switch to remove. reversed steps to replace.

r/r parts unit runs great

i first popped off the top of te dryer after removing the two screws in frotn when you open the door. I then removed the two screws holding the front together. after tilting the front out i was able to place the slides in without having to pull of the front entirely.

Repair was VERY easy - 4 screws total! Used google to find a video online that showed the steps.

Initially purchased just the plastic slides, but when I opened the dryer I found the top drum bearing was smashed and the plastic was basically gone in a whole section, so I then ended up ordering the bearing as well. If you hear the loud squeaking, just buy the top drum bearing and the 4 slides (two white and two dark green). It is an easy repair and the squeaking sound is gone.

We removed the top of the the dryer and then removed the front part. Then put the traps in place, put the other parts of the dryer back on, and turned the dryer back on. Just as simple as that. No extra fees.

snap in snap out

First I removed the 2 screws that hold the lid down. Then I pulled the lid off. Then I removed the 2 screws that hold the front of the dryer in place. Then I lifted the drum a little and pulled the front cabinet out a little so I could see the drum slides. I removed the bad drum slides and installed the new ones. I then put everything back together and turned on the dryer. The squeeky noise was gone.

I pulled the panel off of the dryer, screwed the part back on the correct wires, replaced the panel.

I followed the directions from the previous post. It was much easier than described. I got the part, removed 4 screws, removed the top, pulled the front and replaced the part. It was all together again in 15 minutes. Dryer sounds great again! I'm so glad I didn't call a repair man!

Pulled power plug. Removed the "Start/Stop knob" Removed 4 starbit screws across the top of the control panel. Flipped control panel down(toward front of dryer)to expose swithes. Aligned the new switch next to the switch being replaced, removed a wire and re-installed on the new switch. I did for each wire. To remove old switch, rotate counter-clockwise and lift out. Line up slots on new switch to panel slots, push down and rotate clockwise to lock in place. Re assemble panel, line up slot on switch knob to switch shaft and press on.