Inglis Dryer Drums and Tubs

Your Price

$51.53

Two-Piece Split Ring Bearing

★★★★★

(10)

PartSelect Number PS334199

Manufacturer Part Number 279441

This is a replacement bearing ring kit for your dryer. The bearing rings are found on the top and bottom lips of the dryer drum. If your dryer is unusually noisy, or the drum will not turn during operation, or if there are marks left on your clothes after a cycle, you may need to replace the bearing ring kit. The kit comes with 2 bearings, one for the top and one for the bottom of the dryer drum. Remove the front panel of your dryer to access the dryer drum for this repair. At this point you can use a pair of needle nose pliers to release the old bearing rings from the drum. Snap the new bearing rings on, and reassemble the dryer to complete your repair.

Fixes these symptoms

Marks left on clothes
Noisy
Will not tumble
See more...

Installation Instructions

Edward from Andover, NJ

Dryer was sqeaking loudly when running

I Looked on internet sites for this type of problem.
Most sites said the support rollers could cause this.
I found your site PartSelect and with help of your diagrams of the machine ordered the parts I thought were needed plus other parts that might cause the problem.
With machine torn down I replaced the rollers.
I had also ordered the main drive belt and idler assembly with the rollers and these also needed replacement. It is a good idea to order other suspect parts when doing this type of repair since you can return the parts not needed.
Your return policy is great.

Edward Brennan Read more...

Your Price

$70.15

Drying Rack

★★★★★

(5)

PartSelect Number PS346849

Manufacturer Part Number 3406839

This dryer drying rack is great for drying shoes and other items that cannot tumble dry. This dryer rack fits dryers that are 29 inches wide, have the letter "E" following the numbers in the model number, and whose dimples are four and a half inches apart in the back of the dryer drum.

Installation Instructions

Keith from Shawnee, KS

I had only seen a one piece rack .The 2 piece threw me for a loop.

I thought I had checked the arm piece of the rack real good for a product number on my original part but I missed the number till the 2nd box came in, and a looked real careful and realized it was the same as the order I thought was bad.
Put the spring arm in first and the rack will fit in the front groove.
It would have been good if there had been a picture of the dryer arm attached to the dryer.
So I have 2 good racks and will return one if you tell me where to send it.
Keith Walden.. Read more...

Your Price

$72.30

Tall Drum Baffle

PartSelect Number PS11743769

Manufacturer Part Number WP692490

Sold Individually - Appliance originally takes 2.

Installation Instructions

John from Santa Margarita, CA

Dryer belt worn out, rear seal worn replaced drum baffle

Unplugged unit and removed top and front of dryer. Removed drum and belt. noting how belt ran through the belt tension-er. Removed old felt seal from rear of drum. Replaced broken baffle, replaced rear seal. reinstalled belt. Put unit back together and test ran. Read more...

Your Price

$55.06

Drying Rack - Dimples 9.5" apart

★★★★★

(2)

PartSelect Number PS346509

Manufacturer Part Number 3404351

This Whirlpool/Kenmore made dryer drying rack is great for drying shoes and other items that cannot tumble dry. This dryer rack fits whirlpool made dryers that are 29 inches wide, have the letter "E" following the numbers in the model number, and whose dimples are nine and a half inches apart in the back of the dryer drum.

Installation Instructions

Robert from BLOOMINGTON, IL

I was sent a drying rack for my electric dryer

The drying rack sent matched the dimples,9.5 inches apart, but it was an inch and a half too long. The rack sent was 21 inches, I need a rack that is 19.5 inches long. So I returned it. At TWICE the cost of the rack itself. Still in search of a rack that will fit my dryer Read more...

Your Price

$63.18

RACK-DRY

★★★★★

(1)

PartSelect Number PS1487158

Manufacturer Part Number 8212450A

Your Price

$59.26

Bearing Ring

PartSelect Number PS11741469

Manufacturer Part Number WP3394508

Fits around the front of the drum.

Fixes these symptoms

Noisy
See more...

Installation Instructions

Matthias from BEVERLY HILLS, CA

Belt broke

Unscrew the lintfilter opening, lift the upper plate, open the front panel and lower panel. Take the broken belt out and insert the new belt. Close everything and start the dryer. That’s it. Read more...