Roper Washer Bearings

Your Price

$90.87

Roper Washer Centerpost Bearing And Seal Assembly

★★★★★

2 Reviews

PartSelect Number PS334447

Manufacturer Part Number 285203

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Fixes these symptoms

Leaking
See more...

Your Price

$9.62

Roper Washer Spin Tube Bearing

★★★★★

1 Review

PartSelect Number PS11746369

Manufacturer Part Number WP8546462

This spin tube T-Bearing is an inch long. Sold individually.

Your Price

$9.62

Roper Washer Agitator Cam Bearing

★★★★★

1 Review

PartSelect Number PS11741241

Manufacturer Part Number WP3363661

Introducing the Whirlpool Agitator Cam Bearing, a genuine OEM part compatible with specific models from Whirlpool. This essential appliance part is perfect for ensuring a proper and smooth surface for your agitator cam to rotate on. Designed with precision, this bearing may slightly differ in size and shape compared to other parts but promises uncompromised quality and performance. The installation process is straightforward, though we advise you to unplug the washer before starting and to wear work gloves for protection. Trust in Whirlpool's commitment to durability and efficiency with this Agitator Cam Bearing. Please verify your model before order placement for perfect fit.

Fixes these symptoms

Will not agitate
See more...

Installation Instructions

Craig from Polk City, FL

Washer not agitating

On top of the agitator is a flat cap that is held in place by the friction of an o-ring, there are no fasteners. I would imagine one could get under the lip with a small screwdriver or butter knife to pop it off but I chose simply using my fingernails so as to not disfigure the cap. Under the cap you will find the head of the only bolt that holds the assembly together it is a 7/16 head and because it is in a 4" deep well your will need a 6" extension for your ratchet. Once the bolt is out the top of the agitator, the assembly with the cogs removes by hand. Set the assembly upside down on the counter, slide the black plastic ring off, pull the cogs out with your fingertips, install the new cogs put a new black ring on and set the assembly back in the agitator. Reinstall bolt. As the bolt is down in a tube, you cannot set it in place with your fingers and it will fall out of the socket. To hold the bolt in the socket during positioning you can either put a gob of Vaseline on the bolt head to hold it in the socket or form a small piece of paper over the bolt head and set it into the socket, the friction of the paper will hold the bolt into the socket. Took me less then 10 minutes, good luck Read more...