Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Paul
January 29, 2019
The part number for the knob is 1340849 or 1340349. Small numbers and hard to see. Which part cross references for this part number? Thanks!
For model number GLET1031FSO
Hello, thank you for your inquiry! We do not have any information about the numbers that you provided in our system. For your model, you would need part PS2330889 for the middle 4 knobs, PS419267 for the left-most knob, and PS419268 for the right-most knob. We hope this helps!
3 people found this helpful.
Was this helpful?
Thank you for voting!
Johnny
January 26, 2018
Can the "turn-to-start" selector switch be replaced with a "push-to-start" selector switch? If so what part number will I need to order? How do I access the switch wiring?
For model number FLEB8200DS0
Hello Johnny,
Thanks for your question. We are not showing any alternative to the "turn-to-start" version for your model.
I hope this helps.
2 people found this helpful.
Was this helpful?
Thank you for voting!
Al
December 18, 2018
My Kenmore stack washer /dryer turn on knob for dryer shaft on knob cracked. Just need knob,will this fit?
For model number 417.98702891
Hi Al,
Thank you for your question. No, this knob is not listed under your model number. The part number listed under your model number for the knob is PS12705309. I hope this helps. Thank you and have a great day!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Donna
June 10, 2019
The washer knob for both the cycle and the water temp have been misplaced in a move. Can you help me?
Hello Donna, thank you for contacting us, In order for us to locate the correct parts and repair information we will require the model number of the unit. Once you have located the model number please feel free to resubmit the question and we will be happy to help you. Look forward to hearing from you!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Donna
June 10, 2019
Would like to replace the knob as it was lost in a move
For model number W10534633
Hello Donna, thank you for contacting us, In order for us to locate the correct parts and repair information we will require the model number of the unit.W10534633 is not a valid model number. Once you have located the model number please feel free to resubmit the question and we will be happy to help you. Look forward to hearing from you!
Was this helpful?
Thank you for voting!
Donna
June 10, 2019
Replacement knobs for this washer
For model number W10607373B
Hello Donna, thank you for contacting us, In order for us to locate the correct parts and repair information we will require the model number of the unit. W10607373B is not a valid model number. Once you have located the model number please feel free to resubmit the question and we will be happy to help you. Look forward to hearing from you!
Was this helpful?
Thank you for voting!
Jay
September 11, 2019
Hello. I'm about to order this knob to replace the broken one i have. Is this the right machine for this knob?Thxs for the help.
For model number gcet1031fs1
Hi Jay, this knob 134844470 is compatible with your gcet1031fs1 model. Thank you for your question and good luck with your repair!
Was this helpful?
Thank you for voting!
David
November 6, 2019
Is this the knob to start the dryer ? Not to advance the timing but i need the knob to turn the dryer on once i’ve set the time....
For model number Glet1031fs1
Hello David, thank you for your question. Yes, this Part #: PS2330889 is the start switch knob for the dryer. Good luck with your repair!
Was this helpful?
Thank you for voting!
Francis
February 24, 2020
I purchased do knobs from another company and one of the same model number manufacturer part number one 34844 7 0 and when i got them they did not fit on the shaft they were too tight. Are these Frigidaire parts are Electrolux parts?
For model number GLGT1041AS2
Good Day Francis. Thank you for your question in regards to your unit (Model Number GLGT1041AS2). Based on our research, here are the manufacturer part numbers for the knobs that are compatible with your unit: 1) Dryer control knob (Part Number 134043000). 2) Laundry center control knob (Part Number 134844470). 3) Laundry center control knob (Part Number 134043200). The manufacturer of these parts is Frigidaire. We hope this helps! Best Regards.
I need to replace the timer knob on the dryer. What is the diameter of this knob? The one i currently have is 2.5 inches in diameter and 2.0 inches deep. Thanks.
For model number GLGT1031FS3
Hello Alfred, Thank you for your inquiry. The dryer timer knob for your model is part# 134043000. Hope this helps!
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Knob's plastic hub broken
selected correct replacement knob. used small screw driver to remove small black metal sleeve from switch shaft. (had left that in place to be able to turn on dryer with needle nose pliers while waiting on knob). aligned flat of new knob with switch shaft and gently pressed into place.
Clint from Mobile, AL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
477 of 482 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dryer start knob broke
Googled dryer start knob, Part Select was second site I clicked on, found within 1 min, part was inexpensive, easy to order, arrived quickly and fit perfectly. Excellent online ordering experience.
Cynthia from Athens, GA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
373 of 376 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Knob craked and broke off the start switch
Removed all the knobs but the master washing machine control knob, then the control and cover panels by removing the two screws that held each one. Then removed the end plastic pieces to allow access to screws holding the switch onto control panel. Used pliers to pull wires off the old switch and put them back on new switch. Screwed it back in place and re-attached plastic end pieces. Re-attached the control panel, then the cover panel under the control panel.
This is a combo washer/dryer. First, I replaced the Idler Arm pulley but the noise didn't stop - it was easy to replace with two screws holding a access panel door in the back of the unit. Next I had to take off the front of the dryer unit to access the drum bearing and replace the dryer belt. There were many screws and electrical connections to remove. After replacing the drum bearing, there was a plate on the back that had to be held while attaching the screws from the front. Since I was alone, I taped the plate in place to hold it while I attached the screws.
It is just a knob that starts the dryer. The knob is rather large, but it turns on the dryer. No tools needed. It took 5 seconds.
Heidi from Lakewood, CO
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
93 of 155 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Broken Knobs on two control switches. The switches needed to be replaced.
Had to trial and error my way to getting the control panel off. The parts diagrams on this site were very helpful, but didn't tell the entire story. Started to pull the entire front dryer panel off then found that only needed to remove two panel screws to gain access to all the screws holding the control panel on. With those removed the panel came off as a unit and was easily disassembled. Screws securing the switches are easlily stripped, so be careful. Rest of job was just pulling off wiring clips and reattaching. Everything went back together easily.
Too much force was applied to my knob and it broke.
The cat was not used for mechanical advantage. Rather he was present for worker's safety regulations. He is a bit of a tool though.
Firstly, I removed the knob from the packaging. Secondly, I stuck it on the peg.
I am not a professional repair person and do not condone or recommend any of the methods used during this repair procedure. The views and opinions expressed in this repair story are for entertainment purposes only.
Anthony from San Diego, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
80 of 142 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dryer knob broke and wouldn't turn
Pulled old knob off and pushed new one on
cynthia from Statesville, NC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
72 of 136 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Knob extension that turns on the dryer cracked and it would not turn
Removed broken knob and put the new one on - it worked!
Carol from Toledo, OH
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
20 of 610 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Knob fell off - start switch shaft broken from pliers
Unplug the dryer!! I warned my partner of this at first, but she didn't listen.... got quite a little shock from the wires. Removed the back panel with a phillips head screwdriver, removed the connecting wires from the starter box. One was a bit snug, so I loosened it with some flat-nosed pliers. Twisted the unit and it popped right out! Once the part came in I popped it back in, twisted it until it locked into place, put the connecting wires on and replaced the panel. The knob snapped on easily and it all took about 10 minutes total to do! I'm not much of a repairman or electrician and this was SUPER easy!
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Robert W - September 22, 2020
Verified Purchase
Perfect match
I initially ordered online. Knob looked exactly like the one I needed but did not fit. I called and found I needed a different part number which I did not see online. If I had called vs ordering online you would have paid for the shipping. Since it was my mistake for ordering the wrong part online I had to pay the shipping. Will never order online again. Your service rep did an excellent job ob helping me with the order and the return of the wrong item..
★★★★★
★★★★★
Mary S - May 5, 2020
Verified Purchase
Good part
The was perfect and you are the greatest
★★★★★
★★★★★
Susan M - April 17, 2020
Verified Purchase
Easy!
I have been fighting with my local appliance store to get this knob with no success. Went online with Partselect but in my model number ordered the knob, it arrived and fit perfectly. Thank You!!
★★★★★
★★★★★
Sherri C - November 10, 2019
Verified Purchase
Replacement knob
In the “old days” I would have called a repairman and paid a lot of money to get this knob replaced. Your website made it simple to get the right part on the first try! Thank you.
★★★★★
★★★★★
Nancy L - July 29, 2019
Verified Purchase
All went very well
FYI I am a 90 yr old woman and your web site made it so easy even I could do it! Thank you so very much
★★★★★
★★★★★
Gretchen Z - May 24, 2019
Verified Purchase
Pleased customer
Replacing the knobs was an easy fix .. Dryer is working great.
★★★★★
★★★★★
Roseann U - April 10, 2019
Verified Purchase
Perfect replacement for my dryer
I was unsure of which part to select.. it was the little knob that starts my stackable washer/dryer .. I received immediate help from the online chat and was able to order the correct part. Other websites had the same part for twice the cost.. shipping took about a week.. very happy with my new knob!!
★★★★★
★★★★★
Henry B - November 26, 2018
Verified Purchase
Thanks for being reliable
The part arrived quickly and works wonderfully. Thank you for being a reputable company. Enjoy the day. Sarah
The Fix App makes it easy to manage all your stuff in one place. Just snap a photo and we'll find and store your user manuals, receipts, and product information in one easy-to-find place!
"Like magic. I took a picture of the model number on my refrigerator, and the app identified it right away … Very convenient. I'm impressed." ★★★★★ - Clever Jeff
