Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Carolyn W - September 4, 2018
Verified Purchase
Super easy repair!
Parts were received quickly and the repair actually took maybe 3 minutes total, very easy and now the middle arm rotates instead of getting caught.
< Prev
1
Next >
Customer Repair Stories
Average Repair Rating: 3.6 / 5.0, 3 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Spray arm was deteriorated and leaking bady. Top shelf dishes were not getting clean
Removed top basket. Layed on table upside down. Removed one screw. Removed broken part. Replaced with new part. Installed screw Put basket in dishwasher. Ran a load. Worked perfectly perfectly.
Tommy J. from BRENHAM, TX
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
1 personfound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Upper spray arm assembly broken
Had trouble finding my model dishwasher so i called Part Select and we were able to identify the same parts from a newer model. Repair was to replace the entire spray arm assembly, it went well with no problems.
Glasses in the top shelf had food bits - not rinsing well
The most difficult part of this was figuring out the problem was with the middle spray arm - that it was not spinning (and thus not rinsing the top dishes). I could spin it by hand fine - but if I watched its position while the machine was running (open/close the door) I saw it wasn't moving. I took out the top shelf (with spray arm atta
... Read moreched) and connected it to the garden hose. I could see then that the arm was sagging and hitting the rear connection, preventing it from spinning. To replace I removed the plugs from the top shelf side-rails (bend the rail open with your thumb and tip the plugs out of the rail to the right for the left rail, to the left for the right rail. this is easier than pulling them out the end of the rail). Slide out the top shelf. Turn over, remove the phillips screw and pull off the manifold, and middle spray arm. Replace with the new parts. I also replaced the top spray arm (which was very loose, and probably not spraying well because it was so loose). For this I unclipped the top feed tube and pulled off the old sprayer. Put a towel in the bottom rack of the washer so you don't drop the little pieces into the pump below. The top spray arm simply snaps in with the two connectors (the pointy one attaches through the feed tube).
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
1 question answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Patti
April 15, 2018
Spray arm manifold part #ps11752850 in the diagram shows a cone at the end where it connects. The part order picture doesn't show that cone. I don't have the sealing cone at the end now and I believe that is why I have no pressure in the upper arm . Is that cone a different part or is it included?
For model number GU2455XTST3
Hi Patti, Thank you for the question. This is a manufacturer substitution. Part may differ in appearance but is a functional equivalent to prior parts. The cone part is not needed on this model. Hope this helps!
2 people found this helpful.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11752850
Manufacturer Part Number: WPW10323423
Item is in stock and will ship today if your order is placed before 4:00 PM Eastern Standard Time.
If your order is placed after 4:00 PM EST, the in stock items will ship on the next business day.
On Order
Item is not in stock and usually ships 3-5 business days from the time you place your order.
Special Order
Item is not in stock and usually ships 10-15 business days from the time you place your order.
NLA - No Longer Available
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
[{"position":0,"name":"Home","title":"Home","url":"/"},{"position":1,"name":"Dishwasher","title":"Dishwasher","url":"/Dishwasher-Parts.htm"},{"position":2,"name":"Hose or Tube","title":"Hose or Tube","url":"/Dishwasher-Hoses-and-Tubes.htm"},{"position":3,"name":"WPW10323423","title":"WPW10323423","url":""}]
You added 1 item to your cart
✖
% OFF
$
$
Qty:
Total item(s) in cart:
Order Subtotal
$
*Taxes and shipping will be applied during checkout