Dishwasher Pump Grommet WP913108

I disconnected the dish washer and pulled it out. I laid it on its back, unplugged the electrical wires,removed the electrical magnet and pried the shaft seal out with a flat screwdriver. I gently packed the new seal into place with the flat screwdriver. I connected the electrical magnet and wires. I then installed the dish washer and ran ... Read more it through a cycle. I am pleased to say the dish washer does not leak now.

Had to remove the lower spray arm, then the cover exposing the housing assy. Then turn over the Dw and remove the wiring, disconnet the hoses drain and upper srayer. Release the locking ring. Lift the housing up and out through the DW. Then disassenble the housing removing the motor, drain assembly, and water blade assy. Then install the ... Read more seal on the drain assy on the new unti, re-install the housing parts, and motor, then place in DW, re-install locking ring. re-wire, connect hoses. Replace the lower spray arm. Turn electricty and water and test for leaks. You have to really watch the seals.