Thermostat WP74002390

I thought that the initial problem based on the users manual may had been the thermostat.
Removal of the old unit and installation of the new one was quite simple.
The only time lag was cleaning some of the surrounding areas of the oven as worked progressed.
As it turned out though, the problem wasn't the thermostat, but ra ... Read more ther the igniter.
But, that was a fairly easy job as well!

Lifted the top up, only a few inches as the possibality of kinking the gas line was a issue. Took two screws out and replaced the unit, threaded the thermostat down through the oven. It was a breeze. I am 68 year old woman and did I myself.
Most importantly, the process of getting the part was amazing, ordered it in the AM and receiv ... Read more ed it the next day (no extra charge)and by miday the range was good as new. Great service!

I first unplugged the electric cord and closed gas valve. Then I removed the grates and burners from the cooktop and poped open the cooktop, prying it loose with a flat screwdriver. I was able to lift it about 2 .5 inches, barely enough to get my hand in. I then removed the 2 screws that hold the thermostat in place, unplugged the two wi ... Read more res connecting to the thermostat, noting the red goes on the left side. I then threaded the sensing bulb from the oven back up to the cooktop and removed the whole unit. To install the new one, I just reversed steps. Only cautionary note is with the aluminum tubes under the cooktop. Be careful not to pull them too much or they'll bend beyond repair.

Easily repaired. Removetop grates & burners . Use philips screwdriver to remove one screw holding each of the burner assembly. Pull straight forward thermostat control knob. Remove two philips screws holding old thermostat. Remove thermostat & wire heat sensing unit. (All connected together) reverse above process to install new ther ... Read more mostat & knob.

Removed the burners, unscrewed the gas assembly from the stove top, removed the two screws securing the thermostat, pulled out the old thermostat, installed new thermostat and put back together in reverse order.

Also, I replaced both "orifice fitting assemblies" due to pinched burner gas lines from previous "Mr. Fix-it's" wor ... Read more king on the stove.

Both jobs were easy for the average do-it-yourselfer and needed minimal tools to accomplish.

Had to take off burners and lift off top. Then I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires and removed old element. Then I did all steps in reverse to install new thermostat.