Tumbler Seal WP33313541 | Official Whirlpool Part | Fast Shipping | PartSelect
Tumbler Seal – Part Number: WP33313541
Tumbler Seal – Part Number: WP33313541 Tumbler Seal – Part Number: WP33313541 Tumbler Seal – Part Number: WP33313541 Tumbler Seal – Part Number: WP33313541 https://partselectcom.azureedge.net/Schematics/Maytag/36054.gif

Tumbler Seal

Product Description

Tumbler Seal Specifications

The tumbler seal can be used for the front or rear. Sold individually.

How Buying OEM Parts Can Save You Time and Money

Troubleshooting

This part fixes the following symptoms:

Noisy.

This part works with the following products:

Dryer.

This part works with the following brands:

Maytag.

Part # WP33313541 replaces these:

312968, 313541, 33313541, Y313541.
Customer Repair Stories
Average Repair Rating: 2.3 / 5.0, 2 reviews What's this?
Sort by:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Jim from Los Angeles, CA
Difficulty Level:
A Bit Difficult
Total Repair Time:
More than 2 hours
Tools:
Nutdriver, Pliers, Screw drivers
Parts Used:
WPY312959, WP33313541, 306508, 12001541
Drum rubbing metal to metal on front support
1. Unplugged dryer, removed front (2 phillips screws near bottom) set aside with wires attached
2. Removed front support (4 hex head screws)
3. Drilled out pop-rivets, discarded old glides (why didn't Maytag use rollers?)
4. Riveted new glides in place.
5. (Oops!) trimmed cork pads, smeared with glue, shoved under glides, held down until firm
6. Removed drum (pushed belt back to groove, pulled drum off rollers, lifted belt off drum, worked drum out) Left belt on pulley and tension wheel as pattern when I replace it.
7. Scraped old gasket felt off back chassis and front support
8a. Folded gasket lengthwise and glued into front support channel with fold on outside diameter. It was too short.
8b. (Oops! Why didn't this come with instructions?) Pulled it out, reversed it and replaced it with fold to inside diameter. It fit. Glued ends together.
9. Glued other felt gasket into back chassis. (Good ventilation needed here!)
10. Replaced rollers. (This did have instructions, despite being easy. I didn't use any grease. Experience as a locksmith says don't lube anything that isn't sealed from dust. I also vacuumed out 15 years of dust.)
11. Replaced belt. (The old one looked fine, but I was advised to do the belt and rollers along with the glides.) The grooves touch the drive pulley, the flat goes around the tensioner, and the belt exiting to the left seems like it will rub the pulley, but it doesn't once the drum is installed.
12. Turn the drum around (Nice, it's symmetrical!) and work it back in.
13. Lift the belt around the drum edge (I used bull clips to hold it in place.)
14. Check the belt on the pulleys, move the drum in more, take off clips, move the belt to the groove.
15. put the drum on the rollers, lift the belt out of the groove, and spin the drum a little while watching the pulleys to check it.
16. Screw the front support back in place.
17. Screwed the front on and plugged it in.
It works!
30 of 37 people found this instruction helpful.
Was this instruction helpful to you?
Kerry from South Ozone Park, NY
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Screw drivers
Parts Used:
306508, WP33313541
scraping sounds from drum; dirt marks and ripps on clothes.
Removed top screws and the front cover.
Removed lint filter harness/air vent assembly (two screws inside dryer tumbler, 6-7 screws along vent assembly).
Removed front dryer tumbler sealer panel (2 screws on each side).
Scraped off old felt sealer with screwdriver.
Drilled out remnants of old rivets.
Replaced gliders with cork underneath.
Riveted gliders into position.
Used mighty putty to fill the cut metal around the top of the sealer panel (resulting from the dryer tumbler rubbing without proper gliders).
Glued new felt sealer around tumbler sealer panel.
Reassembled the entire unit in reverse order.
12 of 13 people found this instruction helpful.
Was this instruction helpful to you?
Model Cross Reference

This part works with the following models:

PartSelect Number: PS11741149
Manufacturer Part Number: WP33313541
Brand
Model Number
Description
Maytag
DE106
Dryer - Electric
Maytag
DE107
Dryer - Electric
Maytag
DE110
Dryer - Electric
Maytag
DE18CA
Dryer - Electric
Maytag
DE18CM
Dryer - Electric
Maytag
DE18CS
Dryer - Electric
Maytag
DE18CT
Dryer - Electric
Maytag
DE19CA
Dryer - Electric
Maytag
DE19CD
Dryer - Electric
Maytag
DE19CS
Dryer - Electric
Maytag
DE19CT
Dryer - Electric
Maytag
DE210
Dryer - Electric
Maytag
DE212
Dryer - Residential
Maytag
DE21CA
Dryer - Electric
Maytag
DE21CM
Dryer - Electric
Maytag
DE21CS
Dryer - Electric
Maytag
DE21CT
Dryer - Electric
Maytag
DE22CA
Dryer - Electric
Maytag
DE22CS
Dryer - Electric
Maytag
DE22CT
Dryer - Electric
Maytag
DE23CD
Dryer - Electric
Maytag
DE303
Dryer - Residential
Maytag
DE308
Dryer - Electric
Maytag
DE309
Dryer - Electric
Maytag
DE312
Dryer - Residential
Maytag
DE313
Dryer - Residential
Maytag
DE382
Dryer - Electric
Maytag
DE408
Dryer - Electric
Maytag
DE409
Dryer - Residential
Maytag
DE410
Dryer - Residential