All Installation Instructions for General Electric Refrigerator XSS25GGPFCWW

Right ice bucket Glide broke at the connection towards the front of the freezer

Very simple install.
Take the ice bucket and top shelf off and pull it out of the freezer. Get a nut driver for the bolt holding the auger motor onto the left side glide. Then maneuver the auger motor off the left side glide and take the 2 screws out of the right glide and replace with new glide.

Parts Used:

GLIDE BUCKET Right Hand DISP

Mike from Medford, NY
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

1 person found this instruction helpful.

Was this instruction helpful to you?

Ice built up around evaporator fan blades and blades chipped and broke. Refrigerator was making loud vibrating noises.

Removed ice bucket, and unplugged ice maker. Removed light cover. Removed ice maker. Pulled fan blades straight up and removed. Pushed new blades on to motor shaft. Fairly easy .

Parts Used:

EVAPORATOR FAN BLADE

David from KNOXVILLE, TN
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

1 person found this instruction helpful.

Was this instruction helpful to you?

Cracked dairy door

Clear plastic dairy door snaps into placed at the hinge . No tools required.

Parts Used:

DOOR DAIRY

Robert from FORT BRAGG, CA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

The cover pan glass slipped out and shattered into the kitchen sink.

The glass just slipped back into the spot perfectly. Thank you so much.

Parts Used:

Refrigerator Cover Pan Glass

Dolores from POULSBO, WA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Dairy door was broken.

Received replacement door, aligned it then pressed it into place.
Gee, thanks.

Parts Used:

DOOR DAIRY

Richard from DETROIT, MI
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

replace seal on crisper drawer

spent 10 minutes trying to clip in the seal without any success. I emptied the crisper drawer and removed it flipped it over clipped the seal. replaced the drawer. Secret is to remove the drawer from the refrigerator.

Parts Used:

Crisper Pan Front Gasket

Vincent from TUCSON, AZ
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

noisy refrigerator

I followed your video and completely dismantled the refrigerator evaporator motor, fan, brackets, and grommet, I completely cleaned the refrigerator including the cooling coils. I then ordered the evaporator motor ,fan, grommets, lid bumper, and brackets. The order would take a week to arrive. In the meantime I cleaned and reassembled all the old parts, waiting for the new ones to come. Guess what! The refrigerator was quiet as a mouse. I really did not need the new parts, but I kept them anyway just for good luck. Not bad for a refrigerator that's twenty four years old.

Parts Used:

Lid Bumper

James from NEW YORK, NY
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers, Socket set

1 person found this instruction helpful.

Was this instruction helpful to you?

The ice maker wouldn’t switch from crushed ice to whole cube.

I looked up a YouTube video that showed the step-by-step how to replace the crusher solenoid in my GE side-by-side refrigerator.

Parts Used:

CRUSHER SOLENOID

Suzette from Northridge, CA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

broken shelf face

+The shelf face has little plastic locator clips that snapped off. the shelf face just comes off with a light lift of these two clips and a slight upward pull then lift up and off. The new one slips on with the top slipping onto the top rail of shelf, then push the bottom tow clips over the bottom rail of the shelf. There you have it smooth as glass.

Parts Used:

Refrigerator Handle

Rick from Vacaville, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

4 of 10 people found this instruction helpful.

Was this instruction helpful to you?

Ice dispenser did not dispense ice

Ordered the part on a Tuesday and received the NEXT day. Slid out the damaged part and then slid in the new part!!! Excellent Service from your company and will recommend highly!!!

Parts Used:

Ice Bucket & Auger Assembly

brian from montgomery, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Door was broken

My wife did it in less than five minutes

Parts Used:

DOOR DAIRY

Thomas from BERLIN CENTER, OH
Difficulty Level:
Very Easy
Total Repair Time:
30 - 60 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Slide control was broken

Simply slide new control slide through slot from front.

Parts Used:

Humidity Control - White

Ronald from GROVELAND, FL
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Bucket assembly broke

Slid right in; identical to original part. Took 5 seconds to install.

Parts Used:

Ice Bucket & Auger Assembly

Mike from Rowlett, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Bottom refrigerator drawer cracked tracks

Pull out old drawer and replace with new one.

Parts Used:

Refrigerator Crisper Drawer

Carla from Sublette, IL
Difficulty Level:
Very Easy
Total Repair Time:
30 - 60 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Motor stopped due to corrosion

Uncovering the motor is the most difficult part. Installation is stupid-easy. Put all of the coverings back on in reverse order to the way they were removed. I don't think the ice maker has to come out but we weren't using it so it came out first.

Parts Used: