WU704 Maytag Dishwasher - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Nipple that upper spray arm goes on.
Maytag dealer said the part was unavailable but there I sat looking at it.
Parts Used:
-
Roger from Saganaw, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
stretched door springs
Locked door closed, removed lower access panels with 5/16" nut driver, removed old springs with needle nose pliers, put plastic piece on top curved end of spring and placed on slot in door bracket as shown on instructions with part. Did same thing for the other door spring, used the screw driver to stretch the springs down to the first hole in on the base of the dishwasher on each side. Replace the panels. Job done!
Parts Used:
-
Robert B from Frederick, MD
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Not cleaning properly due to clogged parts.
I disassembled parts from the lower Spray arm to the Rinse Arm. Everything was gunked up, nothing was broken. I replaced the Lower Spray Arm, Secondary Filter, Pump Housing Filter and the Rinse Arm. I re-used The Radiant Shields, Filter Plate, Lower Spray Arm Seals and the O-Ring. Much of my time was spent cleaning before re-assembly. Assembly was no problem. I ran the machine afterward with no problems and very good cleaning results. I ran the videos once before starting. They were very helpful, as were some other people's experiences.
Parts Used:
-
Maurice from Wappingers Falls, NY
-
Difficulty Level:Easy
-
Total Repair Time:1- 2 hours
-
Tools:Nutdriver, Pliers
Was this instruction helpful to you?
Thank you for voting!
The door spring broke in half on the front door of a twenty two year old Maytag dishwasher
Easy repair, I put small marks under the counter to make sure the dishwasher went back in the same spot for easy screwing back in
Parts Used:
-
Robert from Leominster, MA
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
door spring broken
-
Richard from Silver Spring, MD
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
water leaking at door of dishwasher
based on instructions from previous customers, took off front control and door panel, removed old gasket, replaced new gasket by aligning tabs and pulling through with needle nose pliers, leaking stopped
Parts Used:
-
JOHN from SLIDELL, LA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Mice living behind the dishwasher
Mice were living behind and on top of the dishwasher and destroyed the pad. Had to throw it away. Ordering you was easy, and the pad fit perfectly.
Parts Used:
-
julie from golden, CO
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Impeller came lose and just spin on the shaft. Impeller broke when trying to tighten.
Removed everything to get to the impeller, installed new impeller and put everything back together.
Parts Used:
-
Dean from Jamesport, MO
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Pliers, Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!