Models > PFSS6PKXASS > Instructions

PFSS6PKXASS General Electric Refrigerator - Instructions

All Instructions for the PFSS6PKXASS
1 - 15 of 77
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Replace water filter
Unscrew old filter and remove(counterclockwise). Line up arrow on new filter with arrow on connection housing. Turn clockwise till resistance met. Do not overtighten. Follow directions. Simple.
Parts Used:
Refrigerator Ice and Water Filter
  • Alfred from Novato, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
216 of 322 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Pantry drawer lid had broken pivot
First, I have to say I live in the next state over, and I recieved the parts the next day. Yeah! OK, I removed the adjacent drawers *and the removable lower storage shelves on the doors for clearance*. Taking out the broken lid is easy. The new one is a tight fit. The right side has a raised pad on the pivot point, but the left one does not. I worked the peg (pivot point) in on the right side and slowly and carefully pushed the stationary plastic left side in slightly(and sprung the lid slightly) to get enough clearance to get in the left peg without breaking the new lid pivot. While doing this, one has to make sure the shelf immediately behind the lid is in place since there are support tabs located on it, and you will have to rework the thing if you don't get them to mate on the installation.
Parts Used:
Pantry Flip Lid Cover
  • James from Painesville, OH
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    15 - 30 mins
45 of 57 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
water running slow
unscrewed old filter by hand, installed new filter.
Parts Used:
Refrigerator Ice and Water Filter
  • David from Tacoma, WA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
33 of 49 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Pin for lifting the panel broke off
Removed the panel , snapped out the plastic window. snapped the window into the new panel , Install the new panel in the refrigerator
Parts Used:
Pantry Cover Frame - White
  • H. Peter from Shafer, MN
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
20 of 26 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Hing broke to the flipper seale door betwen the french door
Until I figured out that the Metal cover on the divider door had to be removed (pried out) giving access to the hidden hinges. After that the hinges could be removed and replaced.Great with giving phone thou.
Parts Used:
French Door Hinge
  • Lal from Tehachaei, CA
  • Difficulty Level:
    Difficult
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Pliers, Screw drivers
26 of 45 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ice build up blocked the fan and caused the motor to fail.
Unplugged the frig. Removed the food and let the ice build up thaw. Remove the shelves. Remove the 4 screws in the back panel and shelf rack bar. Gently start to pull the back panel toward you working to out a little at a time. There are 2 wire connections in the upper right corner. When disconnected and removed lay the panel face down and remove the 4 screws holding the metal fan panel in place. Two screws mount the fan to the fan bracket. When removed, twist fan 90 degrees and it will be free. A spring clip holds the fan blades on the motor. Use a pair of needle hose pillars to pull the spring clip off. Pull the fan blade off the motor. Reverse the process for reinstallation.
Parts Used:
Evaporator Fan Motor
  • Edwin from VIRGINIA BCH, VA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Screw drivers
10 of 10 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Plastic Hinge Pins Broke on the Fresh Food Door
The repair was fairly simple. The clear plastic viewing panel was removed from the old broken white plastic frame of the door. It snapped out pretty easily and installed on the new door using some care not to break anything else. Then I was able to place the hinge pin in the hole in the side frame and gently bend the door until I could fit the pin on the other side in its respective hole.

Parts Select.com process my order quickly. packaging was excellent. Pars were in original manufacturers boxes and packing. Good job!
Parts Used:
Pantry Cover Frame - White GROMMET COVER SLIDE
  • Ronald from Houston, TX
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
12 of 17 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
slow water flow in dispenser
opened refrigerator door located water filter location in right back corner unscrewd 1/2 turn and out it comes without shutting off water it is a snap to do by anyone and shipment was really quick thanks. People do not call a service tech for something this simple even a child tall enough can do it.
Parts Used:
Refrigerator Ice and Water Filter
  • dwight from phoenix, AZ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
13 of 20 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The French swing part of the door would not go back where it needed to. I had to put it back in place with my hand.
I just replaced the broken spring and the little plastic cylinder that goes over the end of one part of the spring. I placed the plastic part on first and slid it in place, then had to bed the other end of the spring a little bit to place it in the hole. But once it went in, the door worked perfectly. And I'm a 70 yr old woman. So if I can do it, anyone can.
Parts Used:
French Spring Pin French Spring
  • Barbara from TREMONT, IL
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
9 of 11 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
was not making ice cubes
I followed instructions you had posted for another person with the same problem. They were perfect. It took 15-20 minutes complete. The hardest part was lining up correctly when putting back together. The previous instructions were as follow: After removing the ice bucket you need to unscrew the left side bucket slides. Under the slide you will be able to see the ice maker wire harness. Unplug the harness and then push a small tab on the left bottom side to release the ice maker then pull the old ice maker out. Jeanette
Parts Used:
Ice Maker Assembly
  • Jeanette from SEVERN, MD
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
9 of 11 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The peg broke off of the frame of the pantry cover door
Repair was simple. I used a screw driver to help remover the clear window from my broken frame. The clear window just snaped right in to the new frame.
Parts Used:
Pantry Cover Frame - White
  • Marsha from Fairfax Station, VA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
7 of 12 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Old spring in door broke
By hand. It was a very easy fix!
Parts Used:
French Spring Pin French Spring
  • Carol from MENNO, SD
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
5 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Corner of shelf cracked
Watched repair video from this site cleaned off shelf, removed the two bins, lifted it out broken shelf, placed new shelf back in, returned the two bins. One step that would have helped a little would have been to remove the bottom door pockets. This would allow the bins to come out easier.
Parts Used:
Vegetable Pan Cover
  • BOB from ALPHARETTA, GA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
replace filter
just had to unscrew old one put the new one in
Parts Used:
Refrigerator Ice and Water Filter
  • Marie from Philidelphia, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
5 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Nothing to tell it was a replacement
Nothing to tell it was just a replacement part that the old part was removed and the new one inserted. Works like a dream Thanks
Parts Used:
Refrigerator Ice and Water Filter
  • Royce from Pasadena, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the PFSS6PKXASS
1 - 15 of 77