All Installation Instructions for Frigidaire Refrigerator LFHT2117NF3

crisper bin had the bottom corner busted, door shelf had cracked

The Pan was a direct swap, as well as the shelf bin. No tools necessary. I'm sure that a repair person would have cost me double what I paid for the same repair.

Parts Used:

Crisper Drawer

Refrigerator Door Shelf Bin

David from Sterling, VA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

5 of 10 people found this instruction helpful.

Was this instruction helpful to you?

moved into a new home and the inside freezer was iceing next to the freezer gasket.

purchased a new freezer gasket. It is still iceing in the freezer but now all over the top part and down the back. The new gasket does not secure tight enough around the entire freezer door when it is closed. It is secured properly to the door but does not "grab" tight enough when the freezer door is closed.

Parts Used:

GASKET-Freezer DOOR

Sharon from Montague, MI
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins

10 of 25 people found this instruction helpful.

Was this instruction helpful to you?

both shelfs broke after jar slipped

removed both the shelf retainer and shelf bin, replace with the new units ordered from partselet.com. the whole process from searching, ordering, shipping and installing was very easy... thanks for everything

Parts Used:

Refrigerator Door Shelf Bin

Refrigerator Door Shelf Retainer Bin

christine from carson, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Needed to replace shelf

I can't believe I put if off so long... so easy to do and PartSelect was very fast, efficient, and the cheapest vendor for my part.

Parts Used:

Refrigerator Door Shelf Bin

George from Cleveland Heights, OH
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Wear and tear

Super easy. It took longer to remove and replace the stuff in my fridge than it did to install the parts. Removing the top shelf makes it easier. One screw on the drawer support rail and the other two parts just snapped onto the door.

Parts Used:

Drawer Support Rail - Right Side

Refrigerator Door Shelf Bin

Refrigerator Door Shelf Retainer Bin

Thelbert from Alton, VA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Lost the temperature control know

The knob came in the plastic package. It was the correct part. I opened the package and placed the knob on the prongs. Now it works fine.

Thanks
John S.

Parts Used:

Thermostat Knob - White

John from Pilesgrove, NJ
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Door shelf broke

Just snapped into place

Parts Used:

Refrigerator Door Shelf Bin

Erica from Inglewood, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

a shelf retainer on our refrigerater broke off.

well, the retainer broke off, so I waited for the new part to come, and when it came, all I had to do was put it on. putting it on took like a second. there were two hooks that the shelf hooked on, so it was really easy.

Parts Used:

Refrigerator Door Shelf Retainer Bin

Sandy from Edmonds, WA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Broken shelf

Snapped new one in.

Parts Used:

Refrigerator Door Shelf Retainer Bin

Richard from Floweree, MT
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Water inlet valve stuck open

Turned off water to inlet valve. Unbolted valve from back of unit, disconnect water supply line from valve, disconnected water line to ice maker. Put on new compression ring around water supply line. Pressed ice maker line into new valve, installed valve back on unit, then connected main supply line to valve. Works like a charm.

Parts Used:

Water Inlet Valve

Robert from GUNTERSVILLE, AL
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Wrench (Adjustable)

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Only one way on my fridge the two ovals snap into place

Just pushed the grill on

Parts Used:

Kickplate Grille

Kevin from ONTARIO, CA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

the freezer frosted up and the fridge was not getting cold.

I watched the instructional video and did what it said.

Parts Used:

Defrost Thermostat

Sherry from Newberry, SC
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

BROKEN RIGHT DRAWER RAIL

REMOVED STUFF FROM SHELVE AND THEN REMOVED SHELVE AND TURN UPSIDE DOWN REMOVED SCREWW AND REPLACED RAIL AND DRAWERIN TRACKS REINSTALLED SCEW AND RETURNEED TO REFRIGERATOR

Parts Used:

Drawer Support Rail - Right Side

Steven from PARRISH, AL
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Shelfs broke

Replacing was to slide the shelf in on their stubs. My comment about the refrigerator shelfs is they are not made to last. You open the door and one end at the opening side would break. I check to see if it was hanging up however it has plenty of room.
Rev. Richard Gibson, ADT

Parts Used:

Refrigerator Door Shelf Retainer Bin