LFHT2117NF2 Frigidaire Refrigerator - Instructions

Snapped it in shelf in designated slots

My upper and bottom air diffuser was missing.
Purchased both air diffuser and placed it.

Took out old replaced with new. Now it makes ice

Took out top shelf, remove old screw and rail . Replace with new

Disconnect the power. To install the Defrost timer which is located inside the console at the top of the fridge I followed a YouTube video. It is very easy. Keep in mind that the Defrost timer comes settled in defrost mode so the compressor will not start after the power is reconnected.There is a hole in the console just behind the Defrost timer where you engaged it with a flat driver and rotate the clock until the compresor start. Now the compressor works for 6 hours and stop for 20 minutes for the defrosting cicle. The freezer now is freezing the meat!!

just pull the old off and put the new one on the magnetic strip inside the rubber was the key it just grabbed the area real easy.

It was soooo easy. I simply clicked the shelf in place! Thank you so much for all of your help. I love this website!

Order parts on sat.afternoon,and got part on Tues.aand installed in less them 2 min.

placed new shelf on refrigerator door

Unscrewed old rail. Screwed on new one. Replaced drawer. Voila!

inside the freezer compartment, remove four hex head screws from rear panel,lift panel forward and unplug wire assembly from panel. find old defrost thermostat attached to copper tube by clip on back of thermostat, unclip, snip two wires to thermostat, take new thermostat, strip 1/4"of wire from wires in freezer (thermostat is prestripped),insert light blue wire from thermostat and light blue wire from freezer into opposite ends of crimp connector and crimp securely. repeat with dark blue wires. set panel back in freezer,connect plug to back of panel, refasten screws and you are go to go! save yourself the price of a new refrigerator or $300 repair by repairman!

Installed in a snap !!!!

I simply removed the old broken shelf and clipped in the new one. Not a major project however the company went above and beyond due to a problem with the delivery of the part. I live in an 1,800 unit condo. Packages are delivered to a kiosk for pick up. FedEx showed the package was delivered but I did not receive it. When I called PartSelect to advise of the problem, they immediately refunded me for the part I didn't receive and sent another one which I received in a few days. I found the company to be very reliable and customer friendly. I will use them again should the occasion arise.

Installing the new shelf was easy.

Unboxed parts and snapped into place, no tools required . Good price, quick shipment---very pleased !