JVM1540LM5CS General Electric Microwave - Instructions

Ordering was easy and instillation even easier

PartSelect had helpful repair instructions on-line which made the repair easier and faster. Unfortunately, there were other problems with the oven that immediately blew the new fuse I had just installed. It was then determined that additional repair would most likely cost almost as much as a new microwave.

I lifted out the glass plate, put the ring down, and put the glass plate on top of it. Voila!

Removed tray from shipping container and installed in the microwave.

Very easy replacement. Just lift out and replace with a new one!

Ordered missing part and reinstall. Took less than 1 minute. Thanks

Inserted a kitchen knife between the cover and the inside top of the microwave. Pry out the small plastic keeper pin located in the front of the stirrer cover and save for reinstallation. Twist the cover and gently remove. Remove the metal fan and insert it in the new cover. Reinstall the cover and twist to align the hole for the keeper pin. Reinstall the keeper pin and push the cover and pin up tight against the inside of the microwave.

Just like the directions said. Very simple.

First unplugged the microwave, took top grill off, took control panel off, took wires off and used color coded tape to make sure they went back in right places, took fuse out and replaced it and put every thing back and it all worked fine and to top it off my wife did it all. So it was pretty easy.

Took item from sealed box and removed protective bubble wrap. Placed tray in microwave, aligning tray with turntable sprockets. Perfect fit, perfect match! And the part arrived in three days and was very competitively priced. What more is there to stay? Will use PartSelect for other replacement parts. No brainer!

Unpacked glass plate from cardboard box and placed atop rotating spindle inside oven - done.

bought a fuse but that didn't solve the problem. Guess I need a new microwave

Placed the new tray in the microwave.

Removed cover, diagnosed problem, ordered part from Parts Select, received part in 2 days, replaced part, tested and replaced oven into built in space.

This is the tray the glass cooking tray rest on and rotates the glass during cooking. The metal tray was installed upside down. The rotating glass tray was not properly installed. The oven was at a very high temp. and the weight of the utensil on the glass was not supported correctly. Result, big " pop " and broken glass tray. Note this is the second glass repaced. The first one dropped while removing it from the oven. It stuck to the bottom of the cooking dish and then fell to the floor. Pop, big breakage. Maybe you can learn from my mistakes.