JVM1350WWC01 General Electric Microwave - Instructions

Removed three screws from the top front cover and slide it out and following I removed the touch panel and the housing that holds the switches and replaced the bad one.

llation

This repair was easy and could be done by anyone. If you undertake to do this replacement, remember to slowly bend the medal tabs back that hold the lens. Handled roughly these tabs could break off.

This repair can be don in under 5 minutes, easily !!

Remove upper handle screw. This is accessible on the inside surface of the door.

Remove inside trim piece that surrounds door glass. It prys off easily.

With trim off, lower screw is accessible. Remove lower screw.

Align new door handle with holes in door and replace screws.

Replace inside door trim (just snaps in place).

thank you for the video--very clear, responsible, applicable although the illustration was not exactly of our kind of light. the bulb was exactly like the one Hotpoint used in its microwave made in 1989! I will come back to you for parts in the future. (You have the model # from my original order.)

Last week I removed the glass cover that was held in by one screw and removed the burnt out light bulb. I ordered the bulb and left the glass cover off until the bulb arrived. I had to wait until this evening to put the glass cover back on and fasten the screw because I have a window right next to the oven and the sun streaming in made it too difficult for me to see how to put the glass back in and replace the screw.

Removed the control panel, one screw at the top. Removed 2 screws on the door switch holder and removed the door switch. VERY EASY.

Removed the spline around the inside of the door with the flat head screwdriver. Removed the 2 screws holding the broken handle with the phillips screwdriver. . Installed the new handle. Replaced the spline. Job done

Opened door removed exposed screw inside the microwave door. Partially pryed out plastic liner and removed the second screw. Put new handle in place and replaced both screws. Pressed plastic liner back in place. 1-2-3 easy as pie.

Thankfully I read someone else's report. I remove the top screw with ease and then pried off the cover surronding the glass panel enough to get access to the lower screw and removed it. Then I just screwed the screws back into the new handle and snapped the plastic covering back in place and "Bob's your uncle"

remove two screws bend out flaps remove broken glass install new glas bend flaps back to hold glass install two screws. Done.

Piece of cake. Removed plastic band on door to expose second screw. Loosened screws and attached new handle per comments on your website

I read some of the previous blogs on same problem. Followed same steps others took before me and I was done in 5 minutes! Opened the microwave door. Removed the top screw that was visible and then removed the ring around inside door frame by using a simple butter knife to get it going carefully. Removed the hidden screw on bottom of door . Replaced Handle, screwed in top and bottom , attached plastic seal around door by snapping it back in place. Done

First I removed the top screw which is visible when you open the door. Other screw is hidded under the plastic lining (don't know exact part name). I removed the lining with knitchen knife and unscrew the other screw also. And put the new handle in place.

Just as those before me have described, it was very simple. Just open the microwave oven door, gently pry off the plastic ring (note: don't try to operate microwave without ring in place as it will not work), remove the existing screws, replace with new handle, screws, and finally ring which snaps back into place. The most troubling part of the repair, was the cost of the handle. At $60 plus international banking fees, they really have you over a barrell. But I suppose better than the cost of a replacement microwave.