All Installation Instructions for General Electric Dishwasher GDF510PSD1SS

Dish washer would not turn on

took off 2 sheet metal on the bottom, lowered the dish washer, pulled it out enought to unscrew 2 screws, unplugged the old part plugged in the new, put it back together.
Works like a champ.

Parts Used:

Door Latch

Patrick from BROOKFIELD, WI
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Socket set

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Replaced damaged upper and lower rack assembly

Upper rack I had to reuse the old power was assembly but it just snaps into place. Lower rack literally just place on roller track and it was done. No tools required. Extremely satisfied with my purchase. 10/10 recommend!!

Parts Used:

UPPER RACK

Lower Rack And Swb Replacement Kit

Jacob from Welsh, LA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Rubber Coating worn off rack...causing Plates to get rusty on their edges.

Open box...remove old rack from dishwasher...roll in NEW rack. Done!!!

Parts Used:

Lower Rack And Swb Replacement Kit

Peter A from HOLLAND, MI
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Dishwasher would not sense door was latched

Super easy repair, just removed the old latch and replaced it with the new one.

Parts Used:

Door Latch

Robert from CASEVILLE, MI
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Loud banging sound when dishwasher was on.

The base of the spray arm literally just spins a little bit into place like a luer lock. Takes two seconds to replace.

Parts Used:

LOWER SPRAY ARM

Joseph from KENNEDALE, TX
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Kept falling off during use.

Just took old one off & install new one. Snaps on dish rack. Took 5 minutes.

Parts Used:

MID SPRAY ARM

MID CONDUIT Assembly

John from CLIFFSIDE PK, NJ
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

The soap dispenser was not opening during the washing cycle

Took off the door and separated the two door pieces. Unscrewed the old dispenser and replaced it with the new one.

Parts Used:

DETERGENT MODULE

Stephanie from Huntsville, AL
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers

4 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Diswasher was leaking

Drain hose elbow (#326) had a crack in it. Disconnected power, slid dishwasher out and laid on its back. Hose had two pinch clamps to remove. Replace old hose with new one and used standard hose clamps. Put dishwasher back in place and hooked power back up. Entire process took less than 30 minutes. PartSelect had elbow for about $6. GE does not sell just the elbow. They sell whole pump setup for about $106.

Parts Used:

Drain Hose Elbow

Fred from FLORENCE, SC
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers, Screw drivers

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

The diswaher was not pumping out the dirty water

Once I got the dishwasher out of the cabinet, which required removing the top screws and then the lower face plate. I then removed the old pump by disconnecting the hoses, then removing the old pump by pulling it from the hanger wire. I then disconnected the wire harness. I then put the new pump in place in reverse order. The wire harness connections were different, and the new harness that came with the new pump I was not sure how it may have went with this unit. So I hard wired it by sniping out the wire connector on both sides and wire nutting the connections. Once done I put the dishwasher back in place and tested. Worked like a charm.

Parts Used:

Gasket

P1B WASH PUMP KIT

William from SALT LAKE CTY, UT
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers

10 of 25 people found this instruction helpful.

Was this instruction helpful to you?

Dishwasher was not drying

I followed the U tube instructions already put out part select.

Parts Used:

HEATING ELEMENT

Larry from STERLING, CO
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

new dishwasher with broken upper spray arm

The part did not fit at all but not worth it to me to return it. The part I need is about 20 inches in length and the one sent was about 10 inches. I will simply call for this dishwasher to be repaired or replaced.

Parts Used:

Upper Spray Arm

Marlene from FT WASHINGTON, MD
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

dishes were not dry at end of completed wash cycle

Followed the instructions on the video, it was pretty straight forward. It was helpful to know what to expect before hand like removing accumulated water in the drain before removing the flood switch so as not to have that water drain under the dishwasher. Knowing to have a nut driver with magnetic tip was helpful in removing and reinserting the screws. all in all it was pretty easy repair.

Parts Used:

Flood Switch

louis from FRANKFORD, DE
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

The soap dispenser was broken os to save money I ordered one on-line

The repair instructions were great and the repair went well. The repair took less than an hour.

Thank you
Gary

Parts Used:

DETERGENT MODULE

GARY from SOAP LAKE, WA
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Door gasket needed to be replaced

Simple answer- do not try to do this. GE makes you replace the entire door to replace this $3 part or call them and pay $100s to fix it. We decided to replace the entire dishwasher after we went through disassembly (there are no instructions on this) only to find out we could not fix without a brand new door.

Parts Used:

Gasket

Corinna from MOUNT AIRY, MD
Difficulty Level:
Very Difficult
Total Repair Time:
More than 2 hours

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Not fault of Parts Select - WARNING you cannot fix dishwasher with this part.

This is NOT a complaint about Parts Select (GE however has some packaging issues to resolve). It may become a complaint of Parts Select if not resolved to my full refund.

Unable to repair with provided part.

I have performed this repair in the past easily and successfully with part from GE Parts. GE Part Number: WD18X10052

GE Parts currently lists part number above as discontinued with a new GE Part
Number: WD35X10386. However not in stock

Found new part number locally however was missing the hose and plastic molded tubing that connects to pump and provides the actual diverter mechanism. Obviously did not purchase.

Ordered from Parts Select on 2021-12-22 and inquired if their part was complete. I was assured it was and paid for overnight shipping at approximate cost of $30.

Part arrives on Christmas Eve, a day late and incomplete. Called Part Select and was assured I would be reimbursed for full cost of part and shipping and was provided with shipping label to return incomplete part at their cost once their stock personnel verifies my claims.

I have photos of original/damaged but complete part beside new in package incomplete part for record and your use if you request.

Email Greg at:
[email protected]

Parts Used: