FFHT1621TS1 Frigidaire Refrigerator - Instructions

I unscrewed the old drawer support rail and installed the new one. The phone rep. was excellent. He listened to what I needed, looked up the parts for me, and sent me the correct parts the first time. I think the parts arrived within two days, much faster then I expected. I will be doing business with you again whenever I need parts. Thank you for your excellent service. You exceeded my expectations.

Sincerely,

Rob Ponitz

removed shelf. took out screw. replaced support

Very, very easy problem to fix. I took the shelf that the support rails were attached to out of refrigerator. Unscrewed broke piece and screwed in new support rail and simply slid shelf back into refrigerator. Ta~Da! If I can do it, you can do it!

Super easy. We unscrewed the broken rail, and screwed the new rail into place. Much easier than expected!!! We were also pleasantly surprised to have the part arrive the day after we ordered it!

took off bad part-- 1 screw-- took every bit of 3 min. to change

This was a truly easy snap-in repair. Because I live in a small fishing village on the coast of Venezuela, the only difficult part was waiting for the part to arrive. I'm very grateful that Part Select makes ordering parts easy and reliable.

I took out the screw and removed the old rail, then I used the same screw to install the new rail. It took me 2 to 3 minutes. Very easy.

Open the door and slide on the part. No Tools required

replaced

The first thing I did was to remove all the food from the shelf above the drawer. I removed the old support rail that is attached at the rear of the shelf by one phillips screw. I installed the new support and secured it. Partselect was a great place to purchase the part and they shipped the part quickly.

Two screws held the top of the handle to the door and one set screw held the bottom of the handle to the door. All I needed was a phillips screw driver and an allen wrench. It took less than 10 minutes.

First, remove shelf unit from refrigerator and lay glass side down on a large flat surface. Observe, then pay attention to assembly. Spent more time with this, drinking coffee, and playing with puppy, than the actual repair. Only had to remove and replace two
phillips head screws. Replace deli - meat drawer after shelf unit is in place in refrigerator. Check for clearance for door to close.

I Removed the old broken piece and replaced it with the new drawer support, using the screwdriver it was a very simple operation.

Unscrewed the screw that held the suport rail to the shilf and changed the rail. Then I screw in the new rail.

first i removed the screw from the back of the shelf then pulled the old rail off. I sliped the new rail onto the post then replace the rear screw.