CC3531XRL Crosley Range - Instructions

After buying a 'universal' part at Lowe's and it not fitting correctly and shorting out the burner, I went online and found this source for an exact replacement part. Beside having to disassemble the drop in stove burner two or three times it went well when I had the correct part. I lost one screw somewhere and that delayed me a short time to find a replacement. Thus the 1 to 2 hours. It would have been about a 30 minute job if I had been smarter.

It was worth the money for that little screw, since I didn't have to run all over trying to find the right one.

Cut broken wire and existed wire off and put splice on both new and old wires to connect them.
It's easy job.

I just installed the new burners into the proper place and they fit This was very easy to order. Just had to find the model number which the web site told me where to find this. I am very satisfied with the service Thank You

1. Ensure oven is powered down and cool to the touch. For extra assurance, throw the circuit breaker to the range to OFF. 2. Pulling gently but with constant force remove the right rear surface burner element from its receptacle. 3. Remove right rear drip bowl. 4. Using a #2 Phillips screwdriver remove the single screw that holds the vent cover. 5. Lift the oven top, it should latch open. 6. Remove the vent cover - you may need to pry it very slightly with a slot screwdriver if it has never been removed, it tends to stick from accumulated cooking smudge. 7. Clean up the area where the new cover will go. 8. Install the new cover and screw it snugly, but don't overtighten. 9. Using releases on latching struts,lower oven top. (Cautiously, so as not to pinch your fingers as the top drops!) 10. Re-seat the drip bowl and carefully plug the heating element back in, making sure it seats properly in both the electric receptacle socket and how it sits on the stove top drip pan. Done! (Don't forget to switch the breaker back on, if you turned it off.) I explained this in great detail, but it shouldn't take more than 5 or 10 minutes to accomplish the whole task.

10 Minutes for a stove my landlord thought was not fixable (repairman had already cut the wires to the element and capped them)! The delivery person handed me the package, I got out the single tool needed, installed the part, put away the tool, cleaned my hands, and put a pot of water on the stove to boil for pasta. 10 minutes!

So purchased two new 8 inch elements and replaced them.

The repair only took me 10 minutes to do. I purchased the surface replacement kit from partselect.com. The part arrived in two days. The instructions were very simple. I read the instructions on line during my purchase. When I received the new part, I simply did the repair. Including shipping, the cost was less than $20.00. A service call would have been at least 5x the cost. Thank you for being there Partselect. (Tim from south bend indiana)

Starting by me making a substitute prong to keep the stove working while the part this coming by mail. was a piece of cake.

burner replaced

Popped in there real quick. Wish I would have done it sooner, my oven heats up much faster.

New receptacle element. I am a girl and I did it.!!!!

used drill to remove old screw

Shut off power at breaker box. Removed top burner unit. Removed old receptacle (Mounting screw was rusty so I drilld out the old one.) Cut wires from old unit. Stripped wires back on old unit. Attached old and new wire with ceramic wire nut. Attached new unit. Reinserted top unit. Reconnected power and "voila". Wife was smiling again.

Was easy cut the wires of as told to do wire nut the ends together and put back together and tested and worked great. Done