20215 - Instructions

Removed the two screws holding the element in place. Pulled the element forward and disconnected the two wires connected to the element, pushed wires back on new element and replaced the two screws. (Done)

pressed knobs in place

Turn the power off to the oven. Removed two screws on the back of the oven which held the element in place. Gently pulled out element and unhooked it from the clips. I then got the new element and hooked it back into the clips. I pushed it back in and replaced the two screws. Restored the power and turned on the oven. It works like new!

I simply removed all the oven racks so I could reach in, removed two screws, un-clipped the old element and clipped in the new one. Put the screws back in and popped in a chicken ready to bake. Delicious.

Just followed the instructions on this site... :) Unscrewed the front, removed old unit taking care of which wires went where, put in new unit. Voila.

Turned off power to range. Removed oven racks and the two screws holding heating unit in. Pulled out unit and used a small screw driver to aid in pushing the 2 clips off so I didn't have to pull on the wires. Removed unit and connected new unit and reinstalled the two screws. Turned on power. Took about 12 mins. John

First turn off breaker, then take screws out switch assembly,take oid switch out, put new switch on,turn power on.

In response to your question.......everything went perfectly!! The reason?? I read the directions that were very easy to follow. It was a quick, easy repair, and the stove burner is working like new.

Thank you for your help!!

Bob

Removed 4 screws, tilted cover up and lifted out, removed wires from switch, removed 2 screws holding switch, lifted switch out. Replaced with new switch, connected wires, secured cover with the 4 screws. It worked!

Your site helped me determine the problem. You included a video of how to do the repair. The replacement of the parts went just as expected. The parts came quickly and were the correct parts. I could not have asked for a better experience. (I replaced two switches because the knob was loose on the othe one).. Thanks.

removed front of range door. removed old seal and replaced with new seal. clean and reassemble range door. repair very simple and fast.

The video you provided was excellent! Turned the circuit breaker off. Removed four screws, pulled out control panel, took a picture of the wiring to be safe. Disconnected the wires from the damaged control and removed it (two screws removed). Mounted the new control, connected the wiring, replaced the control panel and the four screws. Circuit breaker back on, turn burner on. That's it. Thanks for the video!

I removed the cover plate for the burner switches and verified the wiring on the other switches. I had removed the bad switch a few years ago and I needed to make sure that the wiring was correct. I did not keep the original screws that hold the switch in place, because I destroyed them when I first removed the old switch. The were corroded from years of cleaning solution. I made new screws from longer wall socket screws by shortening them with a hacksaw. The entire process took about 30 minutes to do, and the results were good. The new switch is smoother than the others, but functions exactly the same.

I shut off the power to the unit took out a couple screws , the bad element . Replaced the new element turned on power and that was that a quick process and oven is working like a charm. Thankyou

Took the oven door off hinge. Took door apart pulled off old seal from inside of the inside panel of door. Replaced with new seal.