All Installation Instructions for Kenmore Dishwasher 110773882

A spring was broken in the disposal chopper

I bought the kit because it had other parts that I thought I needed.

Parts Used:

Drain and Wash Impeller Kit

Robert from Sherwood, OR
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Pliers, Screw drivers

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

The coating on the upper rack had rust coming through.

Removed the plugs in the slides, removed the rack, slid the new rack in and replaced the plugs.

Parts Used:

Dishwasher Upper Dishrack w/Middle Arm And Tube

Ernie from Salinas, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

dish washer leaking

Pulled the old gasket out with needle nose pliers, cleaned the slot for the gasket, installed the new gasket, needed no tools. This repair took 5 min.

Parts Used:

Dishwasher Door Gasket - Gray

Gary from Winnemucca, NV
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

The soap dispenser lid was broken

I ordered a dishwasher soap dispenser "lid assembly". When it arrived, it was not an assembly at all but only a lid. I had to reorder a pin and spring, When i finally had every thing, it was an easy repair.

Parts Used:

Dishwasher Soap Dispenser Cover

ed from potomac, MD
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins

4 of 7 people found this instruction helpful.

Was this instruction helpful to you?

SOAP DISPENSER DOOR DID NOT CLOSE.

WATCHED THE VIDEO FOR 2 MINUTES. REPLACED THE 3 PARTS IN LESS THAN A MINUTE. THANKS FOR THE VIDEOS.

Parts Used:

Dishwasher Detergent Lid Spring

Dishwasher Soap Dispenser Cover

Dishwasher Lid Hinge Pin

ROBERT from MAHWAH, NJ
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

4 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Part in the lower rack had rusted out

There was no tools involved the part popped right into place. I received the part within two days from the date placed. It was great.

Parts Used:

Tine Row

Janet from Hollister, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

broken door spring

Pulled dishwasher out from counter. Took cover off and replaced door springs.

Parts Used:

Spring, Door

David from LEONARDTOWN, MD
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

1/4 inch bolt frozen to shaft

The 1/4 inch impeller bolt to shaft would not budge with a nut driver so I had to use a ratchet to loosen it. I could not hold the drain impeller with an adjustable wrench so I had to use a vice-grip. This still did not loosen it so I used an oscillating power saw to cut away at the bottom of the drain impeller being careful to only cut so deep, I didn't want to cut into the motor shaft. Once I had cut some grooves into the drain impeller, I could break it into pieces and remove it. Upon reassembly I tightened the 1/4 inch bolt with the ratchet.

Parts Used:

Drain and Wash Impeller Kit

Elmer from YORKVILLE, IL
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Well, to make a long story short. My husband isn't mechanically inclined. He tried to surprise me and do it himself.???

I went back to the web site to make sure I'd ordered the right part.?? looked at the diagram and then watched your little video.?? He had the part hooked opposite of what was shown. (The arm wouldn't rotate) So I turned it arround. While he was still??. It took me less that 5 min and the dishwasher is working Great.????

Parts Used:

Dishwasher Upper Spray Arm Mount

Jenni G from LEHI, UT
Difficulty Level:
A Bit Difficult
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Old dishrack was rusted and chipped

Removed old rack opened box inserted new rack. So simple sorry I waited so long to replace.

Parts Used:

Lower Dishrack

Donna from Hicksville, NY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

4 of 8 people found this instruction helpful.

Was this instruction helpful to you?

Original lower dish rack was falling apart.

Took out old rack, put in new one. Part arrived on time and was an exact match to the original.

Parts Used:

Lower Dishrack

Chris from La Center, WA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Cap was missing/lost.

Easy fix. It’s a screw on by hand piece.

Parts Used:

Rinse Aid Cap

Jose from Coolidge, AZ
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

water coming out of the washer flooding the floor

I guess some food got caught in the water level sense float and caused it to mal function.
In the diagnosis process, I removed the arm to clean out any debree in the strainer ( found broken glass). I also found that the two rings mentioned above were worn. I replaced them and all is well.
Thank you for fast response with the replacement parts.

Parts Used: