Kenmore Microwave Oven Combo Fuses

Videos!

Your Price

$21.81

Kenmore Microwave Oven Combo Microwave Fuse

★★★★★

21 Reviews

PartSelect Number PS1481237

Manufacturer Part Number WB27X10928

This ceramic microwave fuse is just over an inch in length. It is white in the center, and metal on both ends. This is a 20-amp fuse, and is used to power your microwave. If the touch pad on the microwave becomes unresponsive, the microwave produces little to no heat, or the appliance simply does not turn on, it could mean that your fuse is at fault and needs to be replaced. Because this part contains an electrical charge, remember to disconnect power to the microwave unit before you begin this repair. NOTE: Before you start this repair, ensure that the microwave is unplugged, and the capacitor is discharged. A capacitor stores large amounts of electricity even after your microwave is unplugged.

Fixes these symptoms

No heat
Touchpad does not respond
Won’t turn on
See more...

Installation Instructions

Kim from Cliffside Park, NJ

Microwave completely stopped working

Turned out the issue was easily solved by replacing a single, inexpensive fuse.

First off, UNPLUG THE MICROWAVE.

The fuse is located under the plastic grill at the top of the microwave. It's held on by two screws. Once you've removed the screws and taken off the plastic grill, you go to the right side of the microwave and remove another screw that holds a small metal grill in place. Removing the small metal grill is probably the toughest part of this repair. You kind of have to rock it back and forth a bit to get it to release. Once that's off, you can get to the fuse. I removed the burnt out one with a pair of needle nose pliers. I also put a small piece of cardboard under the fuse when I did this so I didn't accidentally drop it into the innards of the microwave. I did the same thing when I replaced the new fuse. I then plugged the appliance back in and made sure it worked. Once that was confirmed, I replaced both grills. Read more...

Your Price

$5.45

Kenmore Microwave Oven Combo Ceramic Fuse - 20 Amp

★★★★★

3 Reviews

PartSelect Number PS11747931

Manufacturer Part Number WPM0805101

This microwave fuse is just over an inch in length. It has a white ceramic center, and metal on either end. This is a twenty amp 250-volt fuse, and is used to power your microwave. If your microwave will not heat properly, will not turn on, or the touch pad becomes unresponsive, there could be a faulty fuse which should be replaced. Remember, since this part contains an electrical charge, before you replace the fuse from your microwave, make sure that the power is disconnected from the unit. This part is sold individually. NOTE: Make sure your microwave is unplugged, and your capacitor is discharged before you begin this repair. A capacitor stores large amounts of electricity even after your microwave is unplugged.

Fixes these symptoms

Won’t turn on
See more...

Installation Instructions

Jay from Edwardsville, IL

Blows main fuse when the microwave generator start, (cooking function).

Remove microwave from oven cabinet. remove cover and check main fuse with ohm meter.
Tried fuse, it does not blow untill cooking starts.
Check capacitor with ohm meter, after properly performing capacitor dischagre procedure.
Order new capacitor, simple installation. another new fuse and all is good and cooking again. Read more...

Your Price

$11.77

Kenmore Microwave Oven Combo Time Delay Fuse

★★★★★

3 Reviews

PartSelect Number PS3522743

Manufacturer Part Number 3B74133Q

The fuse-time delay may also be known as a line fuse or a microwave fuse, and it is a piece for your microwave. The function of this part is to shut off the microwave if there is a power surge, in order to protect your microwave from damage. You should consider having a service technician install this part as the high-voltage capacitors in a microwave can contain a very harmful electrical charge, even when the microwave is unplugged and has been inactive for some time. The tools that would be needed to complete this installation include a Phillips screwdriver, an insulated screwdriver, and a pair of pliers.

Fixes these symptoms

No heat
Won’t turn on
See more...

Installation Instructions

George from FALL RIVER, MA

Loss of controls and no heat.

Assisted experienced and knowledgeable local repair shop technician. Had no issues during repairs. Microwave worked properly after repairs were completed. Read more...

Your Price

$25.87

Kenmore Microwave Oven Combo Range Upper Limit Switch Lock

PartSelect Number PS236782

Manufacturer Part Number WB24T10060

Your Price

$29.47

Kenmore Microwave Oven Combo Fuse Assembly

PartSelect Number PS10066444

Manufacturer Part Number EAF36358316

Your Price

$83.61

Kenmore Microwave Oven Combo Thermal Fuse

PartSelect Number PS466969

Manufacturer Part Number 5303319550

Your Price

$27.36

Kenmore Microwave Oven Combo Fuse

PartSelect Number PS239596

Manufacturer Part Number WB27X10454

Fixes these symptoms

Won’t turn on
See more...

Your Price

$145.92

Kenmore Microwave Oven Combo Fuse & Holder

PartSelect Number PS8692146

Manufacturer Part Number 318647300

This fuse and fuse holder assembly protects the appliance by interrupting power during electrical overloads. It is commonly replaced when the appliance will not power on or after a blown fuse event to restore safe operation.