Kenmore Microwave Oven Combo Motors

Your Price

$168.15

Kenmore Microwave Oven Combo MOTOR-CONVECTION

★★★★★

1 Review

PartSelect Number PS1993372

Manufacturer Part Number 5304463302

Your Price

$62.90

Kenmore Microwave Oven Combo Motor, AC Synchronous

★★★★★

2 Reviews

PartSelect Number PS3529223

Manufacturer Part Number 6549W1S018C

Fixes these symptoms

Tray won’t turn
See more...

Your Price

$25.13

Kenmore Microwave Oven Combo Motor, AC Synchronous

★★★★★

1 Review

PartSelect Number PS3529217

Manufacturer Part Number 6549W1S013K

Fixes these symptoms

Tray won’t turn
See more...

Installation Instructions

George from RICHMOND HTS, OH

Was making a noise when turning around

I removed the bottom plate which had 9 screws.
than unplug 2 wires to the motor and unscrewed 2 screws, replaced the old motor with the new one and also the coupler. and so far no noise. easy fix. Thanks Read more...

Your Price

$83.76

Kenmore Microwave Oven Combo MOTOR

PartSelect Number PS10066213

Manufacturer Part Number 5304498736

Your Price

$165.07

Kenmore Microwave Oven Combo Upper Cooling Fan Motor with Blade

★★★★★

2 Reviews

PartSelect Number PS237580

Manufacturer Part Number WB26K5061

Installation Instructions

David from Richardson, TX

Replace failed fan in control box

After turning off the breaker to cut power to the oven, I opened the oven door and, using the PartSelect exploded diagram as a guide, I removed 3 screws from the underside of the control panel - I was then able to slide the panel up and out to remove it. Leaving all of the control wires (especially the ribbon) connected to control panel, I saw the fan assembly mounted to the rear of the control box.

I noted the position of the two attached wires - black on top (or left), white on bottom (or right). Using a nutdriver with an extension bar, I unscrewed 4 screws holding the assembly in place. I removed the old fan and installed the new fan in its place. It was necessary to bend the new fan's legs out a bit to get them to line up with the holes. I reconnected the wires as mentioned above, then reinstalled the control panel.

I tested the oven by turning the breaker back on and letting the oven heat up to 450 degrees. The fan turned on as expected. After the oven cooled off, I reinstalled the 3 screws to secure the control panel. Read more...