This fuel filter is for lawn and garden equipment engines. Fuel filter cleans the fuel before it reaches the carburetor. Work in a well-ventilated area when installing this part. Drain the fuel tank and disconnect the spark plug wire before beginning the repair.

This genuine Spark Plug, RCJ8Y, is sold individually, comprised of steel and ceramic, and is white and silver in color. The function of the spark plug is to ignite a mixture of air and fuel in the combustion chamber of your engine. Over time, spark plugs experience wear and tear that can cause your engine to run rough or not at all. Replacement of the spark plug is, therefore, an important part of general engine maintenance. It is also a repair most of our customers rate as easy. You can avoid replacing your spark plug by cleaning it with fine sandpaper, or spraying it with carburator cleaner, then regapping to the manufacturer specs. However, eventually, all spark plugs need replacing, usually once every season or so. Locate the spark plug in the cylinder head, and using a spark plug socket and spark plug gap tool, remove and reinstall your new spark plug. Ensure you regap and tighten your spark plug to the manufacturer specifications.

This ready-oiled air filter is an OEM part that traps dirt and debris, preventing them from entering the engine. This part is black, comprised of foam, and is sold individually. Your air filter may become dirty and clogged over time, and because it is oiled, it is difficult to wash because it is oiled, so it will need to be replaced. A clogged air filter will cause your engine to run rough from restricted air flow. This is an easy repair to make and does not require any special tools.

This OEM carburetor mixes the air-fuel mixture to the proper ratio for combustion in your engine. This carburetor is sold individually, is silver in color and metal in material, and is located on the intake of the engine. Issues with your carburetor will cause problems with your engine running, and could cause excessive smoke due to too much gas. This can happen due to corrosion inside the carburetor. Carburetors can be rebuilt easily, and repairing them requires an allen wrench and a screwdriver. When troubleshooting your carb, remove the air filter and pour a teaspoon of fuel into the carburetor. Pull the starter rope, and if the engine starts then quickly dies, the carburetor is likely the problem. When replacing your carburetor, also replace all gaskets when doing so, as they are a one-time use.

Used to seal the fuel tank to prevent leaks and allow the fuel line to enter through it, this Fuel Tank Bushing is sourced directly from the manufacturer. It is made of black rubber, is not part of a kit or assembly, and is sold individually. This part will wear through regular use and should be replaced if you notice signs of damage or wear. When it malfunctions, you will see fuel leaking from the bushing. You will need a screwdriver and pliers to complete this repair. Customers rate this repair as Easy.

The Starter Pawl bridge provides the resistance needed for the starter rope to start the trimming engine. It is an OEM part that attaches inside the recoil assembly. If broken due to weaar or fatigue, the engine will not engaged when the rope is pulled, and the part should be replaced. Installation is rated as easy and requires a screwdrvier, pliers and nutdriver. Refer to your make, model and diagram to check if this part is correct. This part is metal, individually sold, and comes in gold.

The air cleaner knob, just over 1 inch in diameter, is black in color and made of plastic. It is sold individually, and its function is to tighten the air cleaner cover down on various lawn and garden equipment. This knob can become worn over time, which will cause the air filter cover not to stay in place. Most of our customers find this to be an easy repair. It does not require any special tools.

The air filter prevents dirt and debris from entering the engine on your lawn equipment. This is an OEM filter that is white, roughly 2x3.5 inches in dimension, and can only be purchased individually. Made of foam, the air filter becomes clogged and worn over time, causing the engine to run rough from restricted air flow. You can make this repair easily with no required tools by inserting the new filter inside the air cleaner housing of your engine.

This air filter comes in black foam and is rated as "Easy" to install. Installation requires a screwdriver, and the part attaches inside of the air cleaner housing. This manufacturer certified filter is used to prevent dirt and debris from entering the carburetor and engine, which would cause damage. If broken or clogged, the engine will experience performane issues or may not turn on. If broken, the filter should be replaced. Tip: Put a bit of two-cycle oil in the bag and let it absorb into the filter. This makes it more tacky to catch debris.

This OEM fuel line, or hose, is a 4-inch, clear, plastic tube which is sold individually. It is rated as "Easy" to install. This part connects to the purge assembly and delivers fuel to the carburetor or is used as a return line to the tank. A broken hose will leak, and should be replaced. Refer to your make, model and diagrams to check if this part is right for you.