Dryer Hinges

Shop By Brand

Popular Dryer Hinges

Your Price
$98.29
  On Order
Hinge
★★★★★
★★★★★
(14)
PartSelect Number PS11750410
Manufacturer Part Number WPW10208415
Fixes these symptoms
  • Door won’t close
  • Lid or door won’t close
  • See more...
Installation Instructions
Sandy from MILWAUKIE, OR
One of the hinges broke, making the door sag
Using the Torx Screwdriver, we removed the door from the unit. Then we removed all of the screws on the inside of the washer door. After that we flipped it over and opened it up exposing the inside. We couldn't separate them entirely because there was a screw under the latch piece that we couldn't figure out how to get to. However with all the screws out on the inside of the door, we did have enough room to open it up and access the place cover that holds the hinges in. Once we accessed that we removed the roller tips from the old unit and placed them on the new one. Then we reversed the process. With a couple screws in we realized we had put the hinge in reversed from what it needed to be, so we reopened it and switched it around. Then completed replacing all the screws and reattached it to the washer. It opens and closes perfectly and we saved a couple hundred dollars for sure, as the quote to come out had been a $150 trip charge. Read more...
Your Price
$38.87
  In Stock
Door Hinge
★★★★★
★★★★★
(9)
PartSelect Number PS8722560
Manufacturer Part Number 00491647
This door hinge is designed for use with dryers. The door hinge supports the door and allows the door to swing open and closed with ease. The hinge is made of metal, and it is easy to install, you will need a screwdriver. While holding the door, remove the four screws found on the cover plate of the door, this will allow you to remove the door from your appliance and access the hinge. Once the door is removed make sure you save the plastic bushings from the original hinge. You will then remove the two larger screws on the hinge, then slide the hinge straight up, and pull it out of the appliance. Place the plastic bushings on the new hinge, attach the hinge to the dryer, and reinstall the door.
Fixes these symptoms
Installation Instructions
Philip from MOCKSVILLE, NC
Top of door hinge arm broke.
Remove 4 screws on plastic cover of hinge that connects to the door. An assistant will come in handy at this point to hold the door. Then remove 2 screws holding hinge. Push up on hinge and pull out to remove hinge bracket. Hinge pins has plastic covers that need to be in place before attaching to the door. A small amount of vaseline will hold them in place. Read more...
Your Price
$104.15
  On Order
Door Hinge
★★★★★
★★★★★
(13)
PartSelect Number PS11752542
Manufacturer Part Number WPW10310366
This door hinge is used to hold your door on your dryer in place. Most dryers require two and they are sold individually.
Fixes these symptoms
Installation Instructions
Jennifer from Davenport, IA
Door would not stay shut
Simply took door off, four screws. Laid on table top and removed several other screws to get to the inside. Removed latch and replaced. Replaced srews and put door back on. I'm sure I saved us a bunch on a service call. Oh did I mention I'm a mom with a 2 and a 4 year old running around while I did this repair. Back in business now. Read more...
Your Price
$11.03
  In Stock
Door Cable
★★★★★
★★★★★
(5)
PartSelect Number PS11740194
Manufacturer Part Number WP230131
This dryer door cable is intended for use with spring part number PS343422. This cable is compatible with many of Whirlpool/Kenmore's brands of gas and electric clothes dryers.
Fixes these symptoms
Installation Instructions
George from Rochester Hills, MI
Dryer door cable broken
1. Remove the lint filter. Then remove 2 screws at the lint filter housing.

2. At the back of the dryer, remove 2 screws that restrain the hinges for the dryer top. Do NOT remove the hinges.

3. Remove the front lower access panel. It snaps at the top and hinges at the bottom. It can be slipped off the hinges.

4. Remove 2 screws at the bottom of the main front panel

5. The front of the dryer top is held in place by two plastic clips. Use a flat blade screwdriver (with a rag wrapped around the tip to minimize paint damage) to pry the top up at each front corner. Then tilt the top up to just past vertical. You now can see the top of the spring that is connected to the door cable.

6. Open the dryer door. Use a putty knife to pry up the plastic plug that holds the cable in place at the door. Remove the old cable from the door and insert the new one. Be sure the cable end without a hole goes into the dryer door. Replace the plastic plug.

7. Feed the new cable through the main front panel and close the door.

8. Loosen but do NOT remove two screws that hold the main front panel to each side panel. Tilt the bottom of the front panel out about 2 inches.

9. Working through the gap between the main front panel and the side, hook the spring into the hole in the cable end.

10. Working through the open top and the gap on the side, move the spring+cable up to the top. Pass the upper end of the spring through the rectangular hole in the top of the main front panel and hook the end into the small hole there.

11. Repeat for other cable as needed.

12. Reassemble all parts. You may need to hold the top of the drum up as you move the main front panel back into place. Install the main front panel lower screws before tightening the upper screws.
Read more...
Your Price
$101.05
  In Stock
Dryer Door Hinge
★★★★★
★★★★★
(1)
PartSelect Number PS2581349
Manufacturer Part Number 137105100
This door hinge is for dryers. Door hinge supports the dryer door on the front panel and allows the door to pivot open and closed. Wear work gloves to protect your hands when installing this part.
Fixes these symptoms
Your Price
$7.56
  In Stock
Control Panel Hinge
★★★★★
★★★★★
(2)
PartSelect Number PS11741968
Manufacturer Part Number WP387402
Sold individually.
Your Price
$4.33
  In Stock
HINGE
PartSelect Number PS11759966
Manufacturer Part Number 4774FA4016N
Fixes these symptoms
Your Price
$3.85
  In Stock
Door Hinge
★★★★★
★★★★★
(1)
PartSelect Number PS8756812
Manufacturer Part Number WE1M1033
Screws NOT included.
Fixes these symptoms
Your Price
$28.26
  In Stock
Door Hinge
PartSelect Number PS1145652
Manufacturer Part Number 134412400
Sold individually.
Fixes these symptoms
  • Lid or door will not open
  • Lid or door won’t close
  • See more...
Installation Instructions
High Hope Employment Service from Milan, MO
The handle to the door had been broken.
We had to remove the screws and take the door off the washing machine then the door glass ring. Replace and put it back on. It was really easy and save alot in repair bills. Read more...
Your Price
$52.31
  In Stock
Hinge
★★★★★
★★★★★
(1)
PartSelect Number PS3523444
Manufacturer Part Number 4774EL2001A

Brands