Simplicity Lawn Mower Starters

Your Price

$3.99

Simplicity Lawn Mower Starter Pawl-Ratchet

PartSelect Number PS8942598

Manufacturer Part Number 281505S

The manufacturer-approved Ratchet Pawl (Starter Pawl) comes in a set of two (2). This part attaches inside the recoil assembly, and is used to engage the flywheel. if broken due to wear/damage it will have a hard time engaging the fly wheel, making the engine harder to start, and should be replaced. Installation is rated as "Easy" by customers, and will require a screwdriver, pliers and nutdriver. Refer to your make, model and diagram to ensure this is the correct part for you.This model is plastic and comes in white.

Your Price

$20.78

Simplicity Lawn Mower Pulley/Spring Assembly

★★★★★

2 Reviews

PartSelect Number PS8988822

Manufacturer Part Number 498144

Your Price

$143.85

Simplicity Lawn Mower Motor Starter

★★★★★

2 Reviews

PartSelect Number PS11829347

Manufacturer Part Number 593934

This authentic manufacturer sourced replacement part is designed for use with lawn and garden engines. The starter motor provides an initial motion, engage the flywheel to start the engine. This starter motor features a 14 tooth metal gear. To complete this repair you would need a wrench.

Your Price

$15.80

Simplicity Lawn Mower Pulley-Starter

PartSelect Number PS8942071

Manufacturer Part Number 295871

Your Price

$54.79

Simplicity Lawn Mower Starter-Rewind

★★★★★

2 Reviews

PartSelect Number PS8981884

Manufacturer Part Number 497680

This recoil starter is for lawn and garden equipment engines. Recoil starter spins the crankshaft to start the engine when you pull the rope.

Installation Instructions

Seikai from MARICOPA, CA

starter rewind cord broke

I found the model number of the Briggs & Stratton engine on the inside of the engine housing. Ordered a new starter-rewind unit, as the old cord broke and the thing was well worn. The instructions were clear enough, but to get the old starter off I had to drill out four rivets, which just spin around when you try. I used a hacksaw, chisel, pliers, whatever worked on each rivet; this took a while. When they were finally removed, the new starter pull unit was relatively easy to install with the small nuts and bolts provided. On the Yard Machines log splitter, putting back the engine housing is quite tricky; you have to jostle the thing into place, get the pull handle above the cover and line up the bolt holes. Read more...