Ridgid Angle Grinder Parts

Ridgid Angle Grinder Assembly Brush Genuine Ridgid replacement part, this item is sold individually. 2 of these Brushes are needed for a set. This Brush includes the Brush, Brush Holder, Brush Spring and plug in terminal. It is always best to replace both brushes, even if only one is worn. Worn brushes frequently are the cause behind a motor running poorly. Replacing brushes can fix a motor that's operating intermittently. New brushes can restore a motor's electric braking. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

Ridgid Angle Grinder Clamp Nut This item has been sourced from the original manufacturer to be used with angle grinders from Ridgid. The metal clamp nut is used to secure the grinding disc to the spindle assembly. The clamp nut requires a spanner wrench to install. This item is sold as an individual replacement part.

Ridgid Angle Grinder Backing Flange This backing flange is a high quality replacement part that helps to secure the grinding disk. It is a genuine OEM supplied item that is specially designed for use with Ridgid grinders. Please note this durable metal item is sold individually.

Ridgid Angle Grinder Spacer-tooless It is an authentic OEM part which is made for Ridgid angle grinders. This is the special spacer which is secured between the guard and the output shaft assembly. If the hardware is missing or is damaged, this will provide an identical replacement for the original component that was installed on a new unit. This high-quality spacer is made of durable material and is sold as an individual item. Refer to the owner's manual and the appropriate diagram for your model to ensure the proper replacement procedure. A screwdriver will be needed to remove and reattach the guard when performing this repair.

Ridgid Angle Grinder Guard Assembly

Ridgid Angle Grinder Assembly Carbon Brush The purpose of a carbon brush is to conduct electric current by maintaining physical contact with an armature. Over time brushes will wear away eventually requiring replacement. Symptoms of worn brushes include erratic or intermittent operation, decreased power, or a complete inability to activate the sander. This is a genuine OEM supplied replacement part that is designed for use with Ridgid angle grinders. One durable carbon brush with a lead wire and a spring are included per order. It is advised to replace both brushes at the same time.

Ridgid Angle Grinder Wheel Grinding