Water Valve 00622058

Hello Rosemary, Thanks for your question. Turn off your water supply valve and the power to the dishwasher prior to any of these steps. Remove the screws to release the lower access panel. Remove the access panel (it is sharp, be careful). Open the dishwasher door and remove the screws securing the outer door panel. Close the door and pull the panel down to remove it. Disconnect the water line from the inlet valve, and be ready for some water to spill out. Remove the brass elbow from the inlet valve. Uninstall the mounting screws to let the old valve go. Disconnect the wiring and use pliers to remove the clamps securing the fill tube, then pull it off the valve. Install the new valve by connecting the tube and securing the clamp, then reversing the above procedures. I hope this helps.

Hi Keith, Thank you for your question. If there is water coming into the dishwasher when it is not in use, then the issue is likely the drain hose. If it is laying flat, then water will seep back into the dishwasher. Use a twist tie and attach it to a hook so it is up higher and does not allow water to flow back into the dishwasher. If it is fresh water that is leaking into the dishwasher, then the issue is the water inlet valve and you will need to replace it as a component in the water inlet valve has failed. I hope this helps. Thank you and have a great day!

Hi Greg, Thank you for your question. Yes, this part is listed under your model and it will work on your dishwasher. I hope this helps. Thank you and have a great day!

Hello Glenn, thank you for inquiring. Yes, replacing this Access Valve for your model will likely fix the problem. You may also want to consider the Float Switch part number PS8697040 for your model. Good luck with your repair!

Hello Sully, thank you for your question. It sounds like your unit is in "Flood Mode". There is a sealed pan on this model with a small sensor that checks for water in the pan. If water gets in the pan it sends the unit into a default drain mode. The drain pan should be dried out. You would then need to determine where the water is leaking from. Check all inlet, and drain hoses, clamps and connectors. If you don't find any water in the pan, then the main electronic control board probably has a short in it and would need to be replaced. I hope this helps!

Hello Ron, Thank you for your inquiry. We would recommend checking the micro filter and the drain pump. You can test the drain pump with a multimeter. Good luck with your repair.

Hello Quentin, Thank you for your inquiry. We confirm that this part will fit your model. We hope this helps you.

Hello Andrea, thank you for inquiring. Yes, this Valve Access is the replacement Water Inlet Valve for your model. Good luck with your repair!

Hello John, Thank you for the question. I would first check to see if the hot water temperature is above 120F. If the water is not hot enough the tablets will not dissolve and the dishes will not come clean. You may have an issue with the Heat Pump, PartSelect Number: PS8736200. Hope this helps, good luck with this repair!

Hello Susan, Thank you for contacting us. I have researched the model you have provided and have found the part you are looking for is PartSelect Number: PS8728724 and is also called Valve Assess. Thank you for your inquiry, good luck with this repair!