Drain Pump - 55Hz 00611332

Hello Ben and thanks for writing. How do I know if my dishwasher drain pump is bad? First, check the drain hose, sink drain and sump to ensure nothing is blocked. If the path is clear yet your drain pump is continually failing to pump out water, the pump has failed. If you notice that your drain pump has visible signs of damage including cracks or dents, or if it has failed, it needs to be replaced. We hope this helps. Please contact us at any time

Hi Theresa, Thank you for the question. The first thing to check is the soap dispenser to make sure it is opening and all of the detergent is coming out. You can also check the spray arms to see if the holes the water sprays through are clear. It is common for them to get clogged over time. You can try to run a empty load and add a cup of vinegar to the water and it will help clean the spray arms. Next you can you start the cycle and after the water fills, open the door to see if the water is at the proper level and the water should be fairly hot so there should be lots of steam. Hope this helps!

Hi Jerry, Thank you for your question. From the sounds of it, the pump can be one of the issues when you are getting the E24 error code. However you may have to take a look at your sensors as well. If those parts are all working, the problem may be in your electronic control board. I hope that helps. Good luck with your repair.

Hello Simon , Thank you for the question. Yes, the impeller can still spin on a defective pump. The Drain Motor could be weak or defective and not able to suck the water through to the drain hose. We hope this helps!

Hello Jon, Thank you for the question. Once the appliance is unplugged and removed from the cabinets you just need to tip the dishwasher back to access the pump. Most customers have been able to do the repair on their own and it is good to heave a second set of hands. We hope this helps!

Hello Larry, thank you for your question. That gasket is only available by ordering the drain pump itself. I hope this helps.

Hello James, Thank you for the question. The pump will need to be removed from the appliance to access the impeller. Thank you for your inquiry, good luck with this repair!

Hi Steve, Thank you for the question. In order to test the pump you will need a Multi Meter to check for continuity. Hope this helps!

Hi Stephen, thank you for the great question. Based on our understanding, the issue is possibly because of the drain pump, part number PS8727352. Replacing the drain pump is easy and can be done at home. The drain pump is located at the bottom of the dishwasher. Un-thread the screws on each side of the door that hold the outer panel, and remove the panel. Remove the access panel by un-threading the screws. Once you removed the access panel, you will have access to the drain pump. Take the wire harness out of the connector. Press in the locking tab on the top and turn the pump clockwise to remove it. To install the new pump, you may follow the instruction backward. We hope this solves your problem!

Hi Martin, Thank you for your question. Yes, this drain pump is listed under your model number and it is designed to work with your dishwasher. I hope this helps. Thank you and have a great day!