Heater Assembly AEG33121501

Hi Kelly, Disconnect the power from your appliance and remove your top panel by removing the two lower screws on the brackets at the back of your machine. Lift the top of your washer off of the appliance and remove your detergent drawer. Then unscrew the two mounting screws from the inner part of your drawer. Remove the screw on the back of your control panel (right side). Pull the plastic of the control panel up and toward you to un-clip it from the machine. Then place the control panel out of the way. Open the pump filter cover at the bottom left hand corner of your appliance. Unclip the drain hose from the appliance and unscrew the screw from the housing. Pull the plastic housing around your drain pump filter out. Unscrew another screw that holds in the outside metal body. Open the door and remove the clamp keeping the bellow attached to the appliance. Push the bellow inside your appliance. Reach in to the right hand side where your door strike pushes in. You will have to disconnect the wire harness from your door lock latch. Once you have done that, close the door again. Remove the five screws at the top of the front panel. After that you should be able to lift the front panel off the hinges at the bottom. Place that to the side and now you have access to the inside of your machine. Place a towel and a plastic container on the floor underneath the drain hose. Pull out the plug and let any excess water drain out. Once that is done plug the hose again. Using a 10mm socket wrench, remove the nut and ground wire of the heater assembly, which is behind the drain pump attached to the bottom portion of the outer drum. Disconnect the wires from both terminals. Using your socket wrench, unscrew the last nut holding your heater assembly in place. You will then be able to pull it out. When installing your new part make sure that it rests on the support bracket inside of the tub. Good luck!

Hello Oscar, Thanks for your question. The tE error code involves a Temperature sensing thermistor error, and you would need part number PS3528953 for the thermistor. I hope this helps.

Hi Jack, Thank you for your question. The issue is a control control problem and based on the information in your manual, it is likely a control issue. You will need to have a technician come out and check the appliance. I hope this helps. Thank you and have a great day!

Hello Craig, Thank you for your inquiry. The PF error code indicates that there has been a power failure to the dryer at that point. You can test the heating element with a multimeter to see if it is working properly. If you are unfamiliar with how a multimeter functions, we have videos available to assist you. The other parts we recommend checking are the safety thermostat, and the wiring harness. We hope this helps and if you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!

Hello Allen, thank you for your question. This is usually caused by a faulty wire at the plug which connects to the Thermistor on the heating element PS3532212. The wash tub Thermistor should read 39.5 K ohms at 86. We hope this helps.