Washer Timer WPW10111389

Hello Mike, thank you for your question. If the timer is not advancing on one cycle but others will work I would recommend . You can test the timer contacts for continuity with a multi-meter but you will require the electrical schematic to determine the correct terminals to check. You can also check the timer motor for continuity with the multi-meter as well. I hope this helps!

Hi Joe, Thank you for your question. Depending on the type of washer you have, there are some parts that you will need to check to see which ones are causing the issue. You will need to check the water inlet valve, the lid switch, the selector and water temperature switches, the water level switch and the timer or electronic control board. I hope this helps. Thank you and have a great day!

Hello Anita, thank you for contacting us. It does sound like the timer is shutting the washer down prematurely, you would need to replace it to fix this issue. Good luck with the repair!

Hi Michael, Thank you for your question. Then I would suggest checking parts like your clutch assembly and your direct drive. Parts that are used to spin your drum. Just to check to see if anything has worn down at all. If those parts are fine, you may have to take a look at your motor start capacitor or the motor itself being the issue. I hope that helps. Good luck with your repair.

Hello Gerald, Thank you for the question. If you can manually start a spin cycle but not a wash cycle, normally it is an indication the timer is defective and will need to be replaced. We hope this helps!

Hello Terry, Thank you for the question. Once the new timer is installed, there is only one way to install the knob. You just need to line the hole in the back of the knob up with the Post from the timer and push it on into place. We hope this helps!

Hi Marcelo, Thank you for your question. If your washer does not drain, there are some parts that you will need to check to see which one is causing the issue. You will need to check the washer lid switch, the pump retainer, the drain pump, the motor, the motor start capacitor, the gearcase and the timer. Also, check the drain hose to see if it is clogged and to see if there are any kinks in it. We have included a link that you may reference on how to check some of these these parts. Once you have determined the part you need, please feel free to call customer service. We are open 7 days a week and anyone will be happy to assist you. We look forward to hearing from you!

Hi Dane, Thank you for your question. If the washer is not filling with water on some of the cycles, the timer is one part to check. There are some other parts that you will need to check to see which one is causing the issue. You will need to check the water inlet valve, the water level pressure switch, the lid switch and the water inlet syphon. I hope this helps. Thank you and have a great day!

Hello Marc and thanks for writing. It could be a faulty timer, but it sounds more like a faulty Water pump PS11741239 and /or a faulty clutch (kick) PS334641 test and replace if needed. We hope this helps. Please contact us anytime.

Hi Michael, thank you for getting in touch. Based on our understanding, the issue could be with the washer timer, part number PS11748352. You may need to replace it to fix the issue. We hope this sorts out your problem!