Ice Bucket WP67005959

bought new

On several occasions the ice bucket had fallen inches onto other frozen foods and the auger wouldn't work. After dealing with this several times over a period of several years, I decided to see if I could locate a replacement which I did through your company; We took the old one out, unsnapped parts and then snapped the new bucket to th ... Read more e gate and shazzam, we were able to slide the new bucket into place and it works like new. Hopefully a repair won't be necessary again!

With a socket set wrench this is the second time it happen no problem

viewed online video, followed steps, my amana had 3 screws instead of 1 screw. with plastic clips. removed l bracket screw, backed off other 2 screws, did not remove. slid ice maker up off 2 screws unplugged wire harness, followed the rest of steps on video. reversed steps for installation. one note, pay attention to how the wire harness ... Read more is clocked it makes install easier because of access.

Firts checked the parts received werer correct for the repair and the correct part numbers ordered. Then removed the ice bucket with the auger in bottom. Emptied ice from original bucket auger assembly. Checked out the removeal of the face cover for the bucket auger and removed it from clips that held it in place. Checked the specificati ... Read more ons of the old ice bucket compaired to the new parts. Installed the aurger assembly into the new ice bucket and removed the two screws from the old unit to use in secure the auger assembly in the new bucket. The only tool needed was a 1/4 inch nut driver. Installed the face place on the new ice bucket auger assembly and tested the fit in the freezer. Ran test of the auger assembly without ice to ck for any misinstlled parts. Refilled the ice bucket with ice and tested with ice to complete the repair.

Removed ice bucket, removed front of old ice bucker, removed ice auger, steralized new bucket and replaced all parts. Slid new bucket in refrig.

I had to pull the old ice bucket out, remove the front cover and the ice churner from the old bucket. The churner had to be installed onto the new ice bucket, then the front cover had to be snapped back on to the front of the ice bucket. Finally, the new bucket was slid into place. The whole process was relatively easy for a non-mechan ... Read more ical person like me, with the help of detailed instructions that came with the unit. The on-line video was also helpful. I would recommend this company to friends.

replaced ice maker and ice bucket with really no problems while watching repair video. had ice making within hours and is working wonderful.

Removed all parts in ice bucket and replaced end cap and bucket.It was very easy and is working great. Thanks for your help

Received a repair quote for 234 dollars from a vendor recommended by Jenn-Air. By ordering through partsselect, I paid approximately 35 dollars for the parts, including shipping charges. The repair instructions were simple to follow and it took me about 30 minutes to replace both parts.