Convection Fan Motor Assembly DG96-00110F

This OEM convection fan motor assembly is compatible with ovens and ranges and assists with heating the appliance by circulating the hot air required for cooking. It comes without any hardware or extra fan blades. If you hear a scraping or scratching noise coming from the convection fan within your range when cooking, or if the fan simply is not moving, the fan motor needs to be replaced as soon as possible. Failing to replace it will cause extended cooking times, inefficient heating, uneven browning of your food, and potential damage to other components. Electrical issues and gradual wear and tear are the most likely reasons why this motor fails or stops working, so to get the best performance, regular cleaning and maintenance are necessary. You can test this motor with a multimeter to check for continuity, in case this is a larger electrical issue within your appliance and not specific to the motor. To replace this motor, turn off your range and disconnect it from power. Pull your range out from the wall and use a screwdriver to remove screws from the back panel. The motor will likely be in the center of the rear panel and will only require you to disconnect it from its wire terminals and unscrew it from the panel while holding on to the fan within the oven with a wrench. Once the new motor is installed, it is important to assemble it with the same hardware as before and to connect the correct terminals with the correct wires.