Quick Question!

Have you ever purchased from PartSelect.com before?

Models > ZSG27NGSASS > Parts

ZSG27NGSASS General Electric Refrigerator - Parts

All parts for the General Electric Refrigerator ZSG27NGSASS

Below is a list of all parts for the General Electric Refrigerator ZSG27NGSASS. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the ZSG27NGSASS
1-14 of 281
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$11.31

Temperature Sensor

This temperature sensor, also known as a thermistor, is used for refrigerators and freezers. The sensor sends the temperature reading of the refrigerator towards the control board....

$13.20

Defrost Thermostat

This defrost termination thermostat acts as a safety device to stop the evaporator coil from overheating, by turning off the defrost heater at the end of the defrost cycle. The thermostat measures the temperature in your freezer to ensure that it stays at an optimum temperature to keep your frozen food from thawing. Some common symptoms linked to a faulty defrost termination thermostat include: the freezer is not defrosting, is too cold/too warm, or there is a frost build up in the freezer. Before you decide to replace this part, ensure that there is no frost build up in your freezer; as a build up can interfere with the thermostat reading.

$65.78

Ice and Water Filter

This is an ice and water filter. The most common reason you would need to change this part is if you have never updated your model and it is no longer filtering your water. This al...

$2.77

Evaporator Fan Grommet - Red

If you notice that your refrigerator or freezer is noisy or too warm, you may need to replace the evaporator fan grommet. This part is red in color, and is about 1 inch in diameter. The evaporator fan grommet is located behind the evaporator fan cover in the back of the freezer. You will need to remove the evaporator fan cover to access the evaporator fan and complete this repair. Before you begin this repair, ensure the power to the refrigerator is disconnected. You will need a pair of needle nose pliers, a small flat blade screw driver and both a 1/4 and 5/16-inch nut drivers to complete this repair.

$19.00

Module Shelf Insert

This part is located in the front of the module shelf.

$7.53

Dispenser Door Assembly or Flapper

The dispenser door assembly (or flapper) is what opens to release the ice once the lever has been pressed. This part mounts in the ice dispenser. The cranker no longer comes with this part. You can use the original crank. The crank is sold separately depending on the model number of the appliance. For this repair, all you will need is a Phillips screw driver and a small flat blade. Disconnect the power, remove the escutcheon from around the dispenser, lift up the control panel, disconnect all wire connectors, use a screwdriver to remove all four screws of the housing, and lift the housing out. You will now see the flapper: push the tabs that are securing it in place to remove the piece, install the new flapper by lining it up and snapping into place.

$41.11

Dispenser Door Solenoid Assembly

This part is a possible option when ice door won't open or shut properly or when water is not dispensing.

$42.14

Dispenser Auger

When activated, the auger rotates and pushes ice out of the bin through the chute to the user.

$27.65

Water Tank Assembly

This tank stores water until the water actuator is activated and water is requested.

$2.58

Dispenser Light Bulb - 12V

Sold individually.

$3.52

Recess Door Spring

$4.07

Light Switch

$1.90

Compression Ring

This compression ring is meant to hold the evaporator fan motor in place in the freezer compartment of your refrigerator. This is is a genuine OEM part. The tools needed to complet...

$13.14

Dispenser Crusher Cover

This part is white in color.

All Parts for the ZSG27NGSASS
1-14 of 281