YKHMS1850SW1 KitchenAid Microwave - Instructions

Unplug the microwave. Then remove the six screws that hold the lower panel which has the light bulb cover and a couple of vent filters. The light bulb sockets are on a fixture that is connected by a quick connect electrical connector. Disconnect that and the whole panel is free to access the bulbs. My bulbs were very fragile and trying to twist them out resulted in the glass twisitng loose with the base still in the sockets. I needed to use a needle nose pliers to remove the bases and then I replaced the bulbs and put every thing back together

Removed turntable
Place support ring in track
Place turntable on support ring.
Easy, peasy!

Husband replaced the bulb

Used a philips head screwdriver to remove one screw holding the light cover. Pulled out the old bulb and inserted the new one. Replaced the cover.

Unscrew lens and direct access to surface light cavity. Removed old light bulbs and replaced with new bulbs. Reassembled lens cover and turned lights on successfully. Took less than ten minutes.

Replacement was easy as outlined in the microwave manual.

Looked up the Whirlpool Co. and ordered the part. It was quite simple. Arrived in 2 days and I simply placed it in the microware. It was very very easy!

E. Robinson

Replacement of new vent grille took less than 5 minutes. I just wished Kitchen Aid made a product that lasted longer than 3 years. My part arrived very quickly, less than a week. Service was great and so was your price. I had no problem locating a replacement part. Kitchen Aid would not give me the parts number so I did not know if I was order the right part. But you photo really helped to narrow the correct part. Thanks

Set in place and installed 2 screws. Took less than 5 min.

Removed old screws and pieces of plastic. Replaced new grill vent with old screws. Could not have been any easier

This wasn't really a repair, just an replacement of the filters, which is a regular maintenance requirement.

Remove two screws, remove grill/bracket, replace grill/bracket, replace two screws and your done. Recycle if You Can.

All it took was 2 screws and it was done - could not have been simpler.

Opened door and put new plate in.

Placed order on Thursday evening and received Sat Am

Took out turntable and swapped out old one with a new bright and shiny
New one, ring that is. It was easy using the part from parts select
Thanks
Paul