All Installation Instructions for Whirlpool Microwave WOC97ES0ES01

LIGHT SWITCH ON LATCH-DOOR BROKEN

REMOVED PANEL COVER [ 4 SCREWS]
UNSCREWED 2 SCREWS ON LATCH DOOR
ON THIS MODEL THE PART WAS IN TOO TIGHT OF QUARTERS SO I HAD TO LOOSEN A TOP PANEL SO I COULD RAISE PART HIGH
ENOUGH TO RELEASE IT FROM A CATCH AT THE BACK OF THE PART. PUSH PART BACK, RAISE AND PULL FORWARDS.
REMOVED 4 WIRES ONE AT A TIME AND ATTACHING TO NEW PART. REPLACED PART, TIGHTEN TOP PANEL AND REPLACED PANEL COVER.

NOT BAD FOR A 91 YEAR OLD

Parts Used:

Range Door Latch

NORMAN from MISSION VIEJO, CA
Difficulty Level:
Difficult
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Wrench set

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Cracked glass tray

Part arrived in timely manner and placed it in microwave oven.

Parts Used:

Microwave Turntable Tray

Richard from SUMMERVILLE, GA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Glass microwave tray broke

Set the new one inside the microwave

Parts Used:

Microwave Turntable Tray

John from Minden, NV
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

4 of 7 people found this instruction helpful.

Was this instruction helpful to you?

The grill support, which is installed on the ceilling inside the microwave broke

The part is pushed against the ceiling into an opening and then turned 90 degree. That is is.

Parts Used:

GRILL SUPPORT

Felix from GREER, SC
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

upper oven of wall oven would not heat suspected high temp limit switch

removed unit from cabinet tested switch it was OK checked wiring and found shorted out wire leading to switch. cut out bad section and spliced wire back together
problem solved

Parts Used:

Thermostat

William from Carbondale, CO
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Open the carton and install turntabe glass tray.

Fool proof.

Parts Used:

Microwave Turntable Tray

Roger from LYMAN, ME
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Countertop Dishwasher - Non Whirlpool

Since I have All Whirlpool appliances in the home, the only one not a Whirlpool was a counter top dishwasher that looks exactly like it could be a Whirlpool and so not to be the odd unit out, I labeled it with with a Whirlpool logo nameplate on the face of the door. Now everything matches perfectly and all in the same exact color white too.

Just measured and marked where the plate was to be located, cleaned that part of the surface, peeled the backing and carefully placed the logo name plate in place and pressed it on. Voila. Done and looks original as well. Call me the big, deep fakearooski.

Parts Used:

Plate

Peter from PLEASANT PR, WI
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Broken glass tray

Just put it in

Parts Used:

Microwave Turntable Tray

Robert from HEMET, CA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Part broken

We ordered element support 3 times and all three times it came broken. The part is made of porcelain and is fragile , representative asked warehouse to pack it in the box and part still came in envelope.
Requested refund and ordered directly from factory.

Parts Used:

GRILL SUPPORT

Elena from HOUSTON, TX
Difficulty Level:
Very Difficult
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Broken mounting bracket for coils in convection microwave.

Very easy, fit perfectly.No tools required.

Parts Used:

GRILL SUPPORT

Larry from Fernandina Beach, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

4 of 10 people found this instruction helpful.

Was this instruction helpful to you?

I broke the glass cooking tray when instaling my oven microwave combo

I put the tray in the microwave???? Pretty easy.

Parts Used:

Microwave Turntable Tray

Jeff from Baytown, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Grill support broke. Sounds like a common problem based on other’s comment.

Turn the grill support 90 degrees to the opening in ceiling of micro. Insert then turn back 90 degrees so the support is in-line with the slot. Hang the wire on the support. Hours of worry over what this was gonna cost me to get repaired, then a 45 second fix costing only 29 bucks.

Parts Used:

GRILL SUPPORT

Andrew from LAKEVILLE, MN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

The ceramic hanger that holds up the element for the convection over broke

Took about 10 seconds... turn the new ceramic holder sideways, push up in the hole, bring the element up to position and twist the ceramic piece 45 degrees into place to hold element. That's it!!! Very simple....

Parts Used:

GRILL SUPPORT

Joyce from Conyers, GA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Inner door glass EXPLODED while preheating!

Easy peasy. After using the shop vac to remove the glass fragments, 8 Phillips head screws were all that I had to remove. The schematic on this website was close enough, but I recommend taking pictures as you disassemble.

Caveat: I took it apart several days before I got the part, so I had plenty of time for my forgetter to work.

Parts Used:

Inner Door Glass

J.M. from Royal, AR
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

INTERIOR OVEN LIGHT

EASILY REMOVED GLASS COVER INSIDE OVEN AND REMOVED SMALL HALOGEN LIGHT BULB.
RECEIVED REPLACED WITHIN TWO DAYS OF ORDER AND REPLACED BULB AND GLASS COVER IN ABOUT 10 MINUTES.
MOST DIFFICULTY WAS HAVING TO BEND DOWN TO REACH INSIDE OF OVEN TO LOCATE POSITION TO INSERT BULB.

Parts Used: