WDTS7024RZ0 Whirlpool Dishwasher - Instructions

There was no tools involved the part popped right into place. I received the part within two days from the date placed. It was great.

Cut DW brackets to size, attached to DW. Bent back tabs, pushed DW into place and installed screws.

Since I have All Whirlpool appliances in the home, the only one not a Whirlpool was a counter top dishwasher that looks exactly like it could be a Whirlpool and so not to be the odd unit out, I labeled it with with a Whirlpool logo nameplate on the face of the door. Now everything matches perfectly and all in the same exact color white too.

Just measured and marked where the plate was to be located, cleaned that part of the surface, peeled the backing and carefully placed the logo name plate in place and pressed it on. Voila. Done and looks original as well. Call me the big, deep fakearooski.

followed directions, a kid could have done it,

Just replaced it in the notches that held the rusted tine.

Our experience was amazing. The part itself simply needed to be replaced: dropped into the lower rack and it was done. The amazing part was the wonderful service that this site provided. We discovered our initial mistake, contacted the company, and received instructions for how to return it. Then we ordered the tine and it was sent immediately. Just received confirmation that the returned lower rack had been received, so the process is complete to our great satisfaction. This site really has it down for providing excellent customer service. They are terrific!! Thank you!

It’s great when you have parts that fit and a schematic to go by. I got both from this site. There are three parts that these screws hold in place. Use the schematic to see which way each part is facing. Line all the parts up and then look through the covers. You’ll see pre drilled holes on either side of the cover. Line the screws up to the pre drilled holes. Put the first screw in half way then insert the second screw all the way. Come back to the first screw and tighten it all the way. Two screws, two minutes and I was done. Real easy repair, just awkward as you are on your belly on the floor. I used a drill with a socket that fit the screw head.

quick and easy,tine-row just snapped right in! Took about 15 seconds!

Inner gasket (Part # PS16221119) was angled in at the corners, so it wouldn't make a seal with the door, resulting in steam leakage and damage to adjacent cabinet door. Simply pulled out old gasket, pushed new one into track and voila, problem solved. New gasket angles out at corners, creating steam-tight seal.

repair by replacement

Went to PartsSelect. Put in Dishwasher model number. Chose the screws for that model number. Ordered the screws. Can't get any easier than that!

Replaced the old rack with a new one. Saved about $30.

Very simple repair when you're supplied with the proper parts. Their delivery time is exceptional !

replace bottom tray with wheels. I recommend get them with wheels already attached. Very difficult to remove old wheels from rack.

I put this unit in about 3 years ago and the brackets broke at the crease and the dishwasher fell forward. Found the right bracket and when it arrived looked a match. Checked link to video showing how to properly install the brackets. The original manufacturer never stated that the tab that goes through the frame is supposed to be bent 90 degrees to prevent the bracket from coming out. Thank you PartSelect for that video because I would probably end up ordering brackets again in a few years.