UMV1160CS0 Whirlpool Microwave - Instructions

Removed one screw lowered glass cover removed burned out bulb replaced with new one put glass back reinstalled screw. Dune 5 minutes back in business

Replaced tray. No tools needed.

Put new plate in and it was fixed

I was sent the wrong fuse by you. I had to procure a fuse in another manner. Very disappointing. The repair was simple. It just took longer because of the failure to send the correct fuse.

Open compartment, installed bulb, closed compartment

took it to Buttermore appliance in Auburn Indiana and he changed the fan and added another fuse

Took the front off and behind a plate was the fuse, so I replaced it for what good that did!!!

I didn't do the repair -- my husband did, said it was easy, had no problems what so ever! The new bulbs give a lot more light to the cooking area.

Opened box, snapped tabs into holes and installed two screws! Elapsed time 3 minutes. Exact part needed was delivered on day given on status page.

Replaced light bulb.

While on your web site and looking at the three parts needed for my microhood oven, I called Customer Service to make certain the parts were correct. The three parts ordered and received were "exact" and easy to replace as instructed with one simple phillips screwdriver. Also, the total price was very reasonable. I would like to also add that the Vent Grille you sent has a much more improved support structure where the mounting screws are inserted than the original. I would, without hesitation, order parts from you in the future than from the major chain store where I purchased the appliance.

Removed the glass cover and replaced the bulb. Very simple.

I had no problem installing the new filter. Just used a phillips screw driver to remove the two screws holding the vent cover in place. Cleaned the dust out of the ducts and reinstalled the new filter. The screws must be held to the screw driver with your finger tips so you don't drop them in the vent cover. The most difficulty I had was in clearing the clean code from the screen. There are no instructions in the owners manual for doing this. But after several tries I got it.

--simpley removed 2 screws, removed old filter--but had PLENTY of cleaning to do before putting in the new filter !My husband LOVES to cook and pan fry foods--it won't go that long before being replaced in the future!

The problem I have with changing the bulb is my microwave is an overhead one and therefore I cannot tip it on its side to easily replace the bulb. I have to drop the lid down and carefully install the new bulb from underneath.