Switch to Classic
Models
>
TB32EC
TB32EC (41BDZ32C766) Troy-Bilt Trimmer - Overview
Sections of the TB32EC
[Viewing 2 of 2]
Keep searches simple, eg. "belt" or "pump".
Carburetor
In Stock
PartSelect #: PS9119300
Manufacturer #: 753-06190
It is an authentic manufacturer-sourced replacement part that i supplied for Craftsman trimmers. The function of a carburetor is to mix the air and the gas into a highly combustible mix before it goes...
$30.42
Bump Head Knob Assembly
In Stock
PartSelect #: PS9306452
Manufacturer #: 791-153066B
This genuine bump head knob assembly, sometimes known simply as the bump head, is black and approximately 2 inches long. Sold individually, this plastic part releases the cutting line. Over time, this...
$12.20
Gear Box Assembly
In Stock
PartSelect #: PS9118330
Manufacturer #: 753-06571
This gearbox is for line trimmers.
Gearbox contains the gears that turn the line spool for cutting.
$39.10
Line Trimmer Spool
In Stock
PartSelect #: PS9119496
Manufacturer #: 753-1155
This spool is for line trimmers.
Spool houses the cutting line and fits inside the cutting head to cut grass and weeds.
Wear work gloves to protect your hands when installing this part.
$20.70
Questions And Answers for TB32EC
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the TB32EC
[Viewing 2 of 2]Engine revs but trimmer head will not turn
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Carburetor replacement
Removed 2 screws securing the air cleaner and carburetor to the engine using a T25 Torx driver. then removed the throttle cable from the carb.Then removed the o ring gasket from the engine and replaced with a new one and replaced the carb etc. Primed it and fired it up.Runs just like new.
Parts Used:
-
William from PALMETTO, FL -
Difficulty Level:Really Easy -
Total Repair Time:Less than 15 mins
7 of 11 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Fuel line broke
Removed the two screws holding the fuel tank to the main unit. Removed the two fuel lines and any stuck on rubber. Installed and installed two screws to mount the new tank. Slid fuel lines on their respective connectors. Done.
Parts Used:
-
Erik from ROBERTSDALE, AL
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
3 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The gear ssembley was not turning
I ordered the gear assembley and the boom assembley and I stalled them.
Parts Used:
-
Ronald from TOOL, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
