Quick Question!

Have you ever purchased from PartSelect.com before?

Models > RUD3000HQ0 > Parts

RUD3000HQ0 Roper Dishwasher - Parts

All parts for the Roper Dishwasher RUD3000HQ0

Below is a list of all parts for the Roper Dishwasher RUD3000HQ0. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the RUD3000HQ0
1-14 of 156
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$46.06

Door Gasket - Gray

This gasket wraps around the sides and top of the dishwasher door and helps seal the door when it is closed to prevent water from leaking from the dishwasher during the washing cyc...

$2.96

Spring, Lid

The dishwasher lid spring helps open the dispenser cover in the soap box when the control releases the latch. If your dishwasher does not dispense detergent, is broken and worn out, or the door is not opening properly, replacing the dispenser spring could be the solution. For this replacement you will need needle nose pliers. First, release the cover on the detergent dispenser, then remove the cover from the shaft it hinges on. Pull the shaft from one side and remove the spring from the shaft. Next, replace with the new spring and engage the two open hooks into the soap cover. Finally, grasp the hook and pull it over tab on the side of the wash cup. Verify that it works properly by opening and closing the cap. Refer to the manual provided by the manufacturer for further instructions.

$4.89

Rubber Washer

The rubber washer is a part which is specific to dishwashers and should not be substituted by a similar part. It works with the heating element to seal the receptacle opening where...

$4.12

Torx Screw

7-18 x 3/4" - sold individually.

$5.23

Pin (Lid Hinge)

$4.37

Soap Cup Latch Kit

This soap cup latch kit, used in a dishwasher, will keep the dispenser cover closed. If your dishwasher will not dispense detergent, there is a door latch failure, the dishes are not cleaning properly, or there is leaking, then this kit can be the solution to your symptoms. The tools required for this replacement are a #15 torx bits, a small blade screwdriver, and slip joint pliers. First locate the soap box and remove the latch on both sides. Next step is to remove the screws in the inner door panel and remove the plastic cover at the back. Remove the old latch assembly and add the new one. Make sure to unplug your dishwasher before beginning this installation project.

$12.63

Soap Dispenser Cover

This part covers your soap dispenser and is spring loaded.

$24.25

Door Latch Bolt

This is a door latch bolt for a dishwasher. The door latch bolt fits on the top of the dishwasher door to keep the door closed while the appliance is running. The latch also prevents the dishwasher from running when the door is not closed, so your dishwasher may not run if the door latch bolt has been compromised. This part does not include the latch lever, so consider ordering that part as well if necessary. It is made entirely of plastic, is black in colour, and is approximately 3.5 inches wide. To access the latch bolt, you will need to remove the inner door panel of your dishwasher.

$2.96

Hose Clamp

This hose clamp is used in a wide variety of household appliances. Most often it is found in washers, dishwashers, refrigerators, freezers, dehumidifiers, garbage disposals, or air...

$17.51

Upper Dishrack Roller Assembly

This part is gray in color and measures approximately 1-1/2 inches wide by 2-1/2 inches high by 1 inch deep. The dishrack roller assembly allows you to roll the rack with ease while the rail supports it. If you notice that the rack is not sliding back and forth easily or the dishwasher is not shutting properly, it may be due to the roller assembly needing to be replaced. The roller assembly may also break or go missing, and will need to be replaced for these reasons, too. You will need to remove the end cap of the upper rack to remove the entire rack. Use a flat-head screwdriver to snap the old roller assembly out of place. The new rollers just get pushed onto the shaft. Use the clips to lock into place. It is common for these rollers to wear down at the same speed, so you may want to replace all the rollers on the rack at the same time.

$6.43

Cap, Wet Agent Assembly

This cap does not require the use of an O-ring seal. The wet agent assembly cap is clear in color and made of plastic. This is a part for your dishwasher. This part may need to be ...

$41.59

Door Switch Kit

This kit comes with 2 micro switches and a wire harness.

$2.96

Screw - 8-18 x 1/2

Sold Individually.

$15.66

Door Panel Insert

This panel is reversible, black on one side, white on the other side.

All Parts for the RUD3000HQ0
1-14 of 156