Models > PVM2070SM4SS > Instructions

PVM2070SM4SS General Electric Microwave - Instructions

All Instructions for the PVM2070SM4SS

diode burnt

it was a simple screw in on both ends. no soldering

Parts Used:

Diode

MANUEL from ESCONDIDO, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Metal flap would not close.

My son fixed it in less than five minutes! easy!

Parts Used:

HINGE-GRILLE (R)

Cathy from San Diego, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

No Power to Microwave

Microwave would not turn on--No lights--Nothing worked 1. Removed screws from back and side and pull off microwave cover. Be careful! There HIGH voltage back there due to a large capacitor that stores power. This capacitor is charged up even with Microwave unplugged. I checked the fuse located on top back part of Microwave. A lot of the time this is the problem but this time the fuse was good. I used an Ohm meter to check to see if there was an open circuit in one of the Thermostats. There are two of them in the Microwave. The Thermostats are about the size of a dime. One is located on the top right side and the other is on the top left side. One of them was bad. I ordered a new Thermostat. It arrived in just 2 days. I installed it and the Microwave was repaired and working great.

Parts Used: