PDW1800N02II General Electric Dishwasher - Instructions

knocked the broken piece off and snapped the new wheels on - easy breezy.

Removed old roller with pilers and pop in New roller really easy very happy partselect had right rollers it made it easy

removed old basket, put new one in

Turn water and electric off. remove\ dishwasher

take of old roller mount and replace new part

















0

I ordered the silverware basket because the original started to separate. The shipment box was damaged and sure enough the handle was broken. The handle can be removed so I replaced the new handle with the old handle, since it was the basket that really needed. Pops off very easily.

Just tool out the old micro filter and put in the new filter.

Need to remove door from hinges to allow to SLIDE gasket thru small lip on door.After using soap and cleaning lip on dishwasher face ,Gasket never feels to grasp lip properly.Identical gasket from old design,just difficult to install.Door latch was also easy to install,BUT LATCH WAS PURCHASED IN LOCKED POSITION.Make sure to roll tumbler in latch ,or it will never lock.

Removed leaking drain hose under the dishwasher from drain pump and sink drain pipe. Fed new hose behind dw connected with new clamps to dw drain pump and sink drain pipe. Put in high loop under sink.

took out the old basket and put in the new basket

manual labor.. And a little help from Milwaukee power tools.

Definately purchase all the wheels (8) as they are smaller than original wheels. Buy the wheel with attached stud. Pull off old wheels and pop these on!

Simply screwed in the new rinse aid cap to replace the old one

I ordered 8 wheels, but I really needed just 4.( I am preventing for the future) It was so very simple to place my order and they were delivered in no time. I simply took off the old one, looked at how they were affixed and put the new ones the same way. Less than 2 minutes to do the entire job. I am a "Handy woman".

1. open dishwasher, 2. roll out bottom dish rack, 3. remove old silverware basket, 4 place new basket in same spot old basket was in, 5. roll bottom dish rack back into dishwasher, 6. close dishwasher door.

The repair piece containing the gasket must be unscrewed and the replacement piece is then screwed into place. Use of a wrench is necessary but used gentle compression as this piece is plastic. Also be careful when starting to thread the piece back on as too much pressure may push the part you are threading it onto out of the back of the dishwasher. ( Note that removing the top rack facilitates the job.. This is done by pushing the locks at the end of the roller tracks in and then to the side, opening the tracks for removal of the rack.)