MAV6300AGW Maytag Washer - Instructions

I popped out the hinge pins, popped outthe busshings, popped out the cam. time less than 10 minutes, pressed in the limit cam, pressed in the bushings, pressed in the hinge pins. time about 5 minutes. the most important thing is my wife is extremely happy. I'm happy the parts fit perfectly.
also the parts arrived in 2 days.

I first changed the belt which helped but it still sounded like it was going to take off through the roof.....I did the pulley and bearing kit in hopes that it would do some good....it went really smoothly with no issues however it did not solve the problem....so it is working and I am going to just ride it out until it quits....thanks

Repaitmr was simple. Followed video instructions from web site. Problem I ordered wrong motor so it just blew my plugs fuse. Also needed pump. Changed motor to old motor installed new pump. Machine works great.

The repair was a piece of cake! I actually stumbled upon PartSelect by searching for the part, it happened to be that the part through your company was the cheapest! Not only did that make me and my wallet happy the part came fast and i was able to repair the washer in 15-30 mins!! Thank you PartSelect!

Used a simple screw driver to push in the lid part...sooooooo simple!!!!!

Replaced pump because pulley did not come off pump without breaking pump in half.

I followed the instructions that other posters suggested. The springs were the toughest part to remove and reinstall. Having my wife push the tub enabled me to use vice grips to get them back on. Read about the coins or washers to spread the springs too late... would have helped. Running a wash now and it's spinning great and no noise!

Replacing the water pump only required the removal of the front Panel, removing and replacing the pump with socket set and then installing front panel with the new clip. Once this was complete the belt drive was installed on the bottom of the washer. Very easy fix.

All I had to do was take off the white cap on top of the spinner, place the dispenser cup in the hole and it was done! It works great even though there was no indication that my model would work with a dispenser. It was the best $3.95 I ever took a chance on!

I followed Gary from Sioux City IA instructions. Very well explained.

I pried up the fabric sotener cover on top of the spindle with a screwdriver and removed it and softner cup holder-it twisted off. I then replaced entire softener unit which I had ordered.

After looking at some of the other stories, I realized this was going to be a super easy fix. I moved the washer away from the wall, disconnected all the lines and then removed the pump. Seriously it took about 20 minutes start to finish, and now the washing machine sounds brand new.

I followed all the instructions from your site. It was very easy. Hardest part was the hose clamps. So it was very easy.

Tilted washer back and removed belt
Lifted front of top and propped up
Unscrewed two screws and removed front of washer
Disconnected two drain lines from tub
Disconnected 6 springs from tub
Removed tub
Popped off bottom plastic cap
Removed locking ring
Slid off gear from shaft
Unbolted screws from snubber support ring
replaced snubber
Put everything back together in reverse order

Worked like a champ!!!!!

Replaced pump. Works great!