All Installation Instructions for Frigidaire Refrigerator LGHT1837LP7

The Refrigerator was not cooling properly. At 40-45 degrees milk spoiled

My upper and bottom air diffuser was missing.
Purchased both air diffuser and placed it.

Parts Used:

Bottom Air Diffuser

Marcos from E STROUDSBURG, PA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Socket set

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

crack

pull off the old gasket and push on the new one into the channel...

Parts Used:

Refrigerator Door Gasket

w l from PIKESVILLE, MD
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

torn and cracked gasket

Took off the old one, replace the new one in less than 5 minutes

Parts Used:

Refrigerator Door Gasket

janet from Parryville, PA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Rail had split and would not support drawer.

Removed drawer. Removed shelve. Flipped shelve over. Removed one screw. Undid tab on each end. Removed bad rail. Replaced with new rail and reversed order. Easy fix.

Parts Used:

Meat Drawer Rail - Right Side

Douglas from HOUSTON, TX
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Freezer no freezing the food

Disconnect the power. To install the Defrost timer which is located inside the console at the top of the fridge I followed a YouTube video. It is very easy. Keep in mind that the Defrost timer comes settled in defrost mode so the compressor will not start after the power is reconnected.There is a hole in the console just behind the Defrost timer where you engaged it with a flat driver and rotate the clock until the compresor start. Now the compressor works for 6 hours and stop for 20 minutes for the defrosting cicle. The freezer now is freezing the meat!!

Parts Used:

Cold Control Thermostat

Defrost Timer - 120V 60Hz

Orlando from FT LAUDERDALE, FL
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Not making ice

Took out old replaced with new. Now it makes ice

Parts Used:

Ice Maker Fill Tube Assembly

Sam from Ravenswood, WV
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Wrench set

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Crisper Drawer Cover frame and Crisper Pan were broken.

Remove and toss broken parts, clean, replace.

Parts Used:

Refrigerator Crisper Drawer Cover

Refrigerator Crisper Pan

Bruce from Woodbridge, VA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

freezer cold and frosting up but refrigerator warm

inside the freezer compartment, remove four hex head screws from rear panel,lift panel forward and unplug wire assembly from panel. find old defrost thermostat attached to copper tube by clip on back of thermostat, unclip, snip two wires to thermostat, take new thermostat, strip 1/4"of wire from wires in freezer (thermostat is prestripped),insert light blue wire from thermostat and light blue wire from freezer into opposite ends of crimp connector and crimp securely. repeat with dark blue wires. set panel back in freezer,connect plug to back of panel, refasten screws and you are go to go! save yourself the price of a new refrigerator or $300 repair by repairman!

Parts Used:

Defrost Thermostat

Gary from SABINSVILLE, PA
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Old door seal was cracked and didn't seal tight.

Pulled off the old seal and put the new one on. No tools needed. It fit where it was supposed to and seals the door like new now! Thank you!

Parts Used:

Refrigerator Door Gasket

Rosemary from FRUITPORT, MI
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Crisper glass shelf installed

Just like the video , just pull out the crisper drawers and slide the new one in. I also made sue that I had a quilt on the floor in case I dropped the glass shelf. Also if you are not sure of the model number you can try calling the store where you bought the appliance at which I had to do. I bought it at Conns and they just needed the phone number I used when I bought it.

Parts Used:

Crisper Glass Shelf Insert

CAROLYN from SAN ANTONIO, TX
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

broken crisper cover--not glass part

replaced broken one

Parts Used:

Refrigerator Crisper Drawer Cover

Susan from NEWBURY, VT
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

I had a broken crisper drawer cover and a missing door shelf on my fridge for as long as I've lived here, so while organizing the fridge one day I decided to see if I could just replace those two parts.

Literally all I needed to do for the door shelf was press it into place, and for the crisper drawer cover so just needed to remove the crisper drawers, lift away the glass shelf (after removing contents from the fridge, obviously) and then remove the drawer frame and replace the broken one (which again, had been broken from before I moved in here almost six years ago!), and then reassemble. It's very nice to have space for seltzer or beer cans in the door and not to have the sagging shelf like I had before. Worth the money and very easy to source.

Parts Used:

Refrigerator Crisper Drawer Cover

Refrigerator Door Shelf Bin

James from MANCHESTER, NH
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

You have sent the wrong part for the THIRD time. You have sent aaccess cover that is TWO INCHES too short. It does not cover the opening, and you will not answer your phones.

There is no way to complete the repair with the wrong part, You have had my order since June 22nd, 2020 and the incorrect part arrived October 27th, 2020. You charged $7.79 plus $1.06 tax and $9.95 shipping. Please refund the entire amount including the shipping, since I did not ask you to ship the incorrect amount.

Parts Used: