Models > KSM3311XAQ0 > Instructions

KSM3311XAQ0 Whirlpool - Instructions

All Instructions for the KSM3311XAQ0
1 - 5 of 5
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
After sitting on my kitchen counter for nearly 42 years the rubber feet left foot prints.
We:
tipped the mixer over on its side
pulled the old feet off
put the new feet in place and pounded them w/our fists
set it back up on its new feet
smiled
Parts Used:
Foot
  • Susan from Gig Harbour, WA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
14 of 16 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The 5 feet on my Kitchen Aide, had worn out
Took the old feet (5) off and put new on the Kitchen Aide, looks great. Stands high and your assistance on the phone, was so appreciated.
Parts Used:
Foot
  • Beverly from Post Falls, ID
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
8 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Missing pedestal foot
Turned the mixer on its side and slid the part into the bottom of the base.
Parts Used:
Foot
  • Michael from CARLISLE, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
4 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Lost a rubber foot on my Kitchen Aid mixer. The remaining feet we're hard and mushroomed. I decided to replace all 5. That was the correct decision.
I griped each foot with a pliers and twisted it out of its setting. I then set a new foot in place and hammered it into place with a small hammer. The feet fit snugly and did not need to be glued. Job was easy and mixer sits like new. I was glad I spent the money to replace all of the feet at once.
Parts Used:
Foot
  • Dale from Manheim, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers
Was this instruction helpful to you?
Thank you for voting!
Base lost grip
Put on a new base plate using fresh screws, all ordered on Parts Select in under a minute. Now my grandmas old Kitchen Aid Stand-up mixer is as good as new! This was way easier than I thought it would be and really a great experience!
Parts Used:
SCREW
  • Miya from Seattle, WA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the KSM3311XAQ0
1 - 5 of 5
Back to Top