KSB5MC4 KitchenAid Blender - Instructions

Watched the video on the site on how to remove the old one and install the new one and it took me all of 5 minutes, at most. I almost threw it away. Super cheap repair. The product arrived in 2 days too. I am saving the site. They are great.

simple clear instructions to follow

Pry off the old, clean up drive threads, thread on the new one. easy as pie

I just followed the instructions to remove the old drive coupling and screwed in the new one.

Forget about the repair blogs. The coupling includes a repair instruction sheet. It actually took longer to read the sheet than it did to do the repair. Follow the repair sheet instructions. Very easy, however not intuitive.

After I discovered that it needed to be screwed on turning to the left it was simple.

easier than i anticipated. i thought i would have to tear the unit down to get this part installed, but the replacement came with (even an idiot can do it)instructions, and it took all of four minutes. Mike in Albemarle,NC..

Pretty muched followed the directions, but after reading all the reviews I knew what do to before the part arrived. Super easy. My blender had been out of commission for a while...now I'm back in business. Well worth the $14 (part and shipping).

with a flat wrench grab the shaft and unscrew the coupling (note: left handed threads)... then install the replacement part.

Just like the directions said, I pryed up on the coupling at a few points around it's circumference and it became loose enough to unscrew. I didn't believe it was going to work at first but, amazingly, it did. All that was left to do was screw on the new part. No problem!

Intructions were simple. Pried off the old coupling with the screwdriver and applied presser to replace the new one on the spindle.

Comment: KitchenAid appliances are made to last unlike most other small kitchen appliances. They are made of strong materials and repairable where as other similar products get thrown out when they break.

It was very easy to unscrew the coupler I used locktight to put on the new part. Thank you sending
the right part the first time
Albert

Released cup drive with screw driver and un-screwed, screwed on new driver.
That is all, works like a new blender.

it was too easy, i only used my hand to screw the coupling to the blender.

The coupling split apart on my Kitchenaid Blender. I ordered the coupling part and "Bingo", I was back in business. It took no time at all and one screwdriver. I saved penty of money by not having to buy a new appliance.