JVM1190WD001 General Electric Microwave - Instructions

Easy as can be. Removed one screw on the glass cover, removed two burned out bulbs and reinstalled two new bulbs, reinstalled the cover and all is well now. The best part - my 'supervisor' is happy that she can see to cook again!

simply unscrewed protective lens cover, and swapped bulbs--these bulbs are great--last for years

Removed the above stove microhood. Removed the side panels & the top panel. Diode located on right hand side of microwave. Removed with screwdriver & replaced new diode. It's best to get the microwave schematic online to pinpoint location of the part.

I removed light bulb cover shield,took out defective bulbs and replaced with new ones. 5minute repair

Removed the one phillips screw that holds the light lens in place, drop the lens down for access to the burned out bulb, screw in the new bulb, replace the lens.

simply to install new bulb. Unscrewed the under the microwave lamp door with a screwdriver. Inserted new bulb into socket. good to go

it was a simple screw in on both ends. no soldering

I took instant pictures at each step to make sure I put the wires back correctly. Removed the front panel. Discharged the capacitor with a voltage meter. Removed parts in front of the magnetron. Removed and replaced the magnetron. Reassembled. Works find now. Small hands, a flashlight and a magnet (for dropped screws) would help. I did not need the pictures.

This is a GE microwave/convection oven about 10 years old. Partselect did excellent job keeping me informed of status and fast delivery. Handle was white; I needed black. So, had to paint it first. Installation tedious. Only need a few tools, but I had to improvise, so took longer. Hardest part was getting to the screws and not breaking the plastic ring around the door. Others are correct. Keep the old screws to reuse. Be careful not to break the clips when you remove the plastic ring to get to the handle screws. Looks good. fits and works fine.