GTS18CBSDRBB General Electric Refrigerator - Instructions

Slipped it it-very easy

Unplug the refrigerator removed the condenser/ compressor cover back bottom on fridge, remove the relay from the compressor took off the two wires, replace with new relay

lifted old broken bar & replaced with new

Just place the shelf door bar in slot and push in place gentle.

Pop out switch, pull wires, attach wires to new switch and pop back in. Easy smeasy!

Remove the top cover above the door by lifting it slightly and pulling forward. I used a mirror to make sure that there was nothing in the way of accessing the switch from above. I used a blade screwdriver to press against the switch retainer on the topside, while GENTLY prying from below with another blade screwdriver to get the switch dislodged. Once the retainer was past the opening, I wiggled the switch downward and then rotated it to the left when the rounded top right edge of the switch was visible. This allowed the wiring to the connector to pass thru the hole. I pushed the wiring from the top and pulled from below to get the connector below the opening for the switch. I then unplugged the switch, plugged in the new switch and reversed the removal process feeding the connector thru first then rotating the switch to the right to get the rounded edge of the switch thru the opening, then pressed the switch up into the opening until it snapped into place. Total time less than 10 minutes.

Removed the old bar and slipped the new one in.

with a jewelry screwdriver I pried the lock tab in and pulled switch down carefully, the hardest part was that the power wire connector was stuck on good but the pliers and the jewelry screwdriver was its match for a bout 5 minute for one connection a simple pull off prong connection. After the wire connected back to switch it popped back in SNAPP

I lifted old one out and place new one in

It was way to ez to install only a couple of minutes that's it

Easy

took a little more effort than the video show to remove old module and replace new. Works fine now.

Took out vegetable draws, removed old cover and put in new vegetable pan cover. Then put back drawers.

Pulled the two wires out from the access hole in the lower part of the refrigerator. Put them in the spade connectors on the new switch, and pushed the switch into place.

All I had to do was remove what I had on the shelf, remove the bins, replace the shelf and slide the bins back in, replace what I had on the shelf and close the door. I am so happy now when I open the refrigerator door and the new (unbroken) shelf has replaced that old broken one.