GT2428PVCW Maytag Refrigerator - Instructions

There was three screws to remove to unmout the ice maker, and unplug the wire harness,then two to remove to slip in new stripper. All took about 20 mins.

Examining the right side rail, which would not stay in, there was a small projection on the outside of it which had sheared off. The fix was a straight replacement, just slide it in from the rear. It took a good bit of force to get the ramped projection over the hump and into its slot.

Removed screws securing the inner door compartment, installed new gasket on door compartment and reinstalled inner door compartment.

At first I went to a local part supplier and they didn't have it in stock but could order it for me for $55.00 plus $10.00 to ship it. I told them I would have to think about it. I went home and got on the computer and found your web site and was I shocked when I saw the same part listed for $6.98 and $7.00 to ship it. You guys saved me $50.00. The part arrived in two day and took 5 min. to install. I now have light in my refrigerator. Thank you.

I opened the box, unwrapped the new ice pan, gave it a cursory rinse, and put it in the freezer.

Remove rails by sliding toward the rear of the draw, remove screw holding roller wheels with screw driver, install
rollers onto new rails, tighten screw, and insert new rails.
Force rails forward till rail locks into place.

removed the 2 screws that held the panel in place, had to reach up and push on locking tabs to lower trhe front of the panel. was able to then push on the locking tab of the switch to release it. removed the wires, replaced them onto the new switch, and snapped the switch into place. the rest was reverse of the uninstall process.

I took the original shelf out of the fridge with the brackets and the slide rail attached. The most difficult part was actually dismounting the slide rail from the bracket so I could replace it. I did this by leveraging the rail away from the bracket with a screwdriver so it could move freely and then banged it out. Once the old slide rail was off I just snapped in the new piece, screwed the wheel from the old rail onto the new one.

Unplug appliance. Socket wrench to unscrew two screws. Module drops down. disconnected two press-on wires by prying off with screwdriver. Removed old switch. Press-fit new switch. Reconnected two wires (color coded). Screwed module back in place. Plug in appliance.

Took out lower shelf. Unscrewed screws holding two broken shelf supports and removed broken supports. Replaced with new supports and screwed in the screws. Nothing to it.

Pry old switch and pull out. Disconect two wires. Put two wires on new switch, must be inserted right and connections not loose. Put switch in, making shure wies do not come off and snap in place

Part was easy to order, delivered quickly, installation very easy. Just unplug the unit, pop out the old swich using a screwdriver, disconnect and reconnect leads and pop switch back in. Definitely recommend that you can do it too.

disconnected el. power to fridge. pried out broken switch with small screwdriner and pulled out w/water pump pliers. installed new switch and pressed into opening.

After disconnecting the electricity. I followed the instructions as indicated in the "HOW TO" article on the website. I used a steel putty knife and pried the light switch out of its retaining hole. I worked the right side the most since this is the side with the retaining clip. After I removed the switch I transferred the two electrical outlets to the new switch and easily snapped it into place. Engaged the electric power and tested the switch.

Was amazed that I could find parts for a model more than 10 years old. Hardest part was figuring out which was the left rail and which was the right. Then it was a snap with no tools