All Installation Instructions for Frigidaire Refrigerator GS18HTZBQ2

It was broken in the front part that hooked in the hole

Took the drawer and shelf out then took the screw out and took the old one out and then put the new one on.

Parts Used:

Meat Drawer Rail - Left Side

Harriet from LOCKWOOD, NY
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Light Switch not working properly

After unplugging the fridge, I took a small flat headed screwdriver and carefully pried off the light switch from the inside, right side of the refrigerator. I disconnected the 2 wires from the switch and replaced it with the new switch and pushed it back into the frame of the fridge. Done !! Very very easy !! Thank you

Parts Used:

Light Switch

William from ORMOND BEACH, FL
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Old door seal was cracked and didn't seal tight.

Pulled off the old seal and put the new one on. No tools needed. It fit where it was supposed to and seals the door like new now! Thank you!

Parts Used:

Refrigerator Door Gasket

Rosemary from FRUITPORT, MI
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Freeze would not re-start after temp rose above 23 degrees.

Unplugged the freezer. Located the Run Capacitor (next to the compressor). Removed the wire holding bracket, removed the Run Capacitor from the Start Relay. Installed the NEW Capacitor, re-installed the holding bracket. Plugged the unit in, looking at the display for the proper start-up sequence data. All is good - freezer operating for another 10+ yrs. NOTE: When removing the Run Capacitor, beware the COMPRESSOR could be HOT to the touch.

Parts Used:

Run Capacitor

Andy from GOOSE CREEK, SC
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

broken crisper cover--not glass part

replaced broken one

Parts Used:

Refrigerator Crisper Drawer Cover

Susan from NEWBURY, VT
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Condenser motor burned out

I followed the instructions on your website, made it a simple as possible. Very tight work area sometimes fingers only, but a little patience works.
Saved at least $300. By not paying a repair person.

Parts Used:

Refrigerator Condenser Fan Motor Kit

Bill from STERLING, VA
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Socket set

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Crisper glass shelf installed

Just like the video , just pull out the crisper drawers and slide the new one in. I also made sue that I had a quilt on the floor in case I dropped the glass shelf. Also if you are not sure of the model number you can try calling the store where you bought the appliance at which I had to do. I bought it at Conns and they just needed the phone number I used when I bought it.

Parts Used:

Crisper Glass Shelf Insert

CAROLYN from SAN ANTONIO, TX
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

You have sent the wrong part for the THIRD time. You have sent aaccess cover that is TWO INCHES too short. It does not cover the opening, and you will not answer your phones.

There is no way to complete the repair with the wrong part, You have had my order since June 22nd, 2020 and the incorrect part arrived October 27th, 2020. You charged $7.79 plus $1.06 tax and $9.95 shipping. Please refund the entire amount including the shipping, since I did not ask you to ship the incorrect amount.

Parts Used:

Access Cover

Jane from EAST JORDAN, MI
Difficulty Level:
Very Difficult
Total Repair Time:
More than 2 hours
Tools:
Nutdriver

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Freezer shelves in two fridgedaire refrigerators were showing rust.

Ordered two replacement shelves which were easily installed. We'll see how long they last.

Parts Used:

Freezer Shelf

Michael from ARNOLD, MD
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

I purchased a refrigerator for the first time, and didn't realize it lacked a freezer shelf!

The part fit perfectly. I simply placed the ends on the holes on the side wall inside the refrigerator, and the other end of the shelf slipped right into the matching holes on the other side. That easy!

Parts Used:

Freezer Shelf

ruth from toledo, OH
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Broke glass on crisper

Just slide glass in. Very easy.

Parts Used:

Crisper Glass Shelf Insert

Carlene from DOERUN, GA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Broken meat pan on Kenmore refrig

Just slid it in. Fit perfectly. Called the Help Line just to double check that the pan would fit and they assured me it would. Pan cost $20 less than through the Sears site because of lower price, lower shipping and no taxes. Oh, and the pan came in just two days. Very happy.

Parts Used: