FH50150 Hoover Water Pump - Parts

Power Switch This item has been sourced from the original manufacturer to be used with upright vacuums from Hoover. The power switch attaches to the power cord and motor. This part is used to relay electricity fro...

Handle Screw Assembly

Upper Handle Assembly

Dump Cap

Recovery

Solution Tank Seal This is a genuine Hoover replacement part. It sits on top of the reservoir. It seals between the clean solution tank and the reservoir, preventing fluid leaks. This small rubber part is sold individually.

Tool Port Door Seal This is a genuine replacement part produced by Hoover. This seal fits between the nozzle and the Port Door (part # 92001325). Just peel the seal from its backing and stick into place; no need for glue...

Upper Cord Wrap The Upper Cord Wrap is an original part sourced directly from Hoover and is used on various models of lightweight upright vacuums. This is located on the back of the vacuum and is where the cord is wr...

Access Door Spring

Cap Assembly - Clean Water Solution Tank This is a genuine manufacturer approved replacement clean water solution tank cap. It is specially produced for Hoover carpet washers. It is utilized to keep the liquid inside the tank. This cap assem...

Lower Handle Assembly The lower handle is made out of plastic. This is available as an individual replacement part. It is a genuine Hoover part sourced directly from the manufacturer for use in vacuums. When replacing this...

Recovery This is an original part sourced directly from Hoover. This high-quality plastic recovery tank is intended for use with the carpet cleaners listed below and is used to collect dirty water produced whi...